Hi, I'm trying to boot barebox on Panda rev. A2. I make panda_xload_defconfig compile and put to FAT SD card partition ranamed barebox.bin to u-boot.bin (MLO reads u-boot.bin by default). Barebox start but after printing revision number is stuck. I add some printks and seems it hang in omap_hsmmc_probe funtion after mci_register(&hsmmc->mci) call. I try with 2 SD cards and non of them is working. Also try to load to flash partition only barebox.bin.itf + barebox.bin but this setup also doesn't work. AFAIU itf add some data before barebox to be possible to boot directly without x-loader. When run_shell is called barebox.bin should be copied do DDRAM and run. Any ideas what should I check. Thanks in advance, marek -- as simple and primitive as possible ------------------------------------------------- Marek Belisko - OPEN-NANDRA Freelance Developer Ruska Nova Ves 219 | Presov, 08005 Slovak Republic Tel: +421 915 052 184 skype: marekwhite icq: 290551086 web: http://open-nandra.com _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
