On Fri, May 20, 2011 at 03:30:19PM +0200, Tim Sander wrote:
> Hi Eric
>
> Thanks for your answer
> > > Is there some obvious error on my side or is there no gpio
> > > support for pcm043? At least there seems to be support for
> > > the gpio ports on imx?
> > > Any hints?
> >
> > you first need to configure the mux of the pins to GPIO mode, then you can
> > use them as gpio.
> After tripping into that trap multiple times, i've already checked that, but
> forgot to mention it:
> static struct pad_desc pcm043_pads[] = {
> ...
> MX35_PAD_D3_CLS__GPIO1_4,
> MX35_PAD_D3_SPL__GPIO1_5,
> ...
Have you checked that you chose the correct iomux setup? These
particular pins can be routed to three different pads each:
#define MX35_PAD_CAPTURE__GPIO1_4 IOMUX_PAD(0x328, 0x004, 5, 0x850, 0, NO_PAD_CTRL)
#define MX35_PAD_SCKR__GPIO1_4 IOMUX_PAD(0x584, 0x140, 5, 0x850, 1, NO_PAD_CTRL)
#define MX35_PAD_D3_CLS__GPIO1_4 IOMUX_PAD(0x68c, 0x228, 5, 0x850, 2, NO_PAD_CTRL)
#define MX35_PAD_COMPARE__GPIO1_5 IOMUX_PAD(0x32c, 0x008, 5, 0x854, 0, NO_PAD_CTRL)
#define MX35_PAD_FSR__GPIO1_5 IOMUX_PAD(0x588, 0x144, 5, 0x854, 1, NO_PAD_CTRL)
#define MX35_PAD_D3_SPL__GPIO1_5 IOMUX_PAD(0x690, 0x22c, 5, 0x854, 2, NO_PAD_CTRL)
Sascha
--
Pengutronix e.K. | |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
