Hi,
What is the status of current barebox on i.MX25 using NAND boot ?
At the first try, it doesn't compile with CONFIG_NAND_IMX_BOOT enabled
as imx_nand_load_image wasn't updated in
board/freescale-mx25-3-stack/3stack.c
- imx_nand_load_image((void *)TEXT_BASE, 256 * 1024, 2048, 16384);
+ imx_nand_load_image((void *)TEXT_BASE, 256 * 1024);
I've loaded barebox in ram using a JTAG and the NAND flash is properly
detected but the badblock scan works only if the NAND was previously
initialised by the JTAG and gives differents results at each run which
seems to indicate something is wrong in the setup.
The platform I'm testing is a i.MX257 TO 1.1 using a 3.3V 8bits width 2k
page size 2Gb NAND from Micron (MT29F2G08AAD).
Thanks,
Eric
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
