On Monday 19 March 2018 11:30:44 Dr. Nikolaus Klepp wrote: > Am Montag, 19. März 2018 schrieb Gene Heskett: > > [...] > > > > I've got jessie on an r-pi3b, and they call it an armhf. Running > > xfce. Color depth could be better, 5,6,5 framebuffer IIRC, makes > > about 7 frames a second, but would also be even slower. Just barely > > fast enough to run LinuxCNC. > > Could you give me a hint where to download a working image? I'm > struggling with RPi+LinuxCNC for ages, almost gave up that project. > > Nik You might try googling for: linux-image-rpi2-rt_4.4.4-rt9-v7+-7_armhf.deb Which will at least give you a kernel that will run it. pin it. I can send that too. The install is armbian jessie lite. Downloadable from the armbian site LinuxCNC is the uspace version of 2.8-pre. Weird config, no PID's used Works fine. PM me, and I can send you what should be working configs IF you've installed and wired up a pair of MPJA's 100 ppr a/b encoders to function as hand wheels. This encoder is also available elsewhere, s/b under $25 a copy. Interface is a mesa 7i90HD, with 3 7i42TA's to protect the 3.3 volt 7i90HD from the noises. Spindle control is a 240 volt single ph input 1.5 hp vfd, running an old (probably about 40 yo) 3 ph, 1 horse I took off a scrapped air compressor. But no use further cluttering this list, so PM me. -- Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> --------------------------------------------------------------------- To unsubscribe, e-mail: trinity-users-unsubscribe@xxxxxxxxxxxxxxxxxxxxxxxxxx For additional commands, e-mail: trinity-users-help@xxxxxxxxxxxxxxxxxxxxxxxxxx Read list messages on the web archive: http://trinity-users.pearsoncomputing.net/ Please remember not to top-post: http://trinity.pearsoncomputing.net/mailing_lists/#top-posting
