On Fri, 2015-09-25 at 15:08 -0700, Andy Grover wrote: > On 09/24/2015 03:25 AM, Andrzej Pietrasiewicz wrote: > > Hello All, > > > > I am trying to set up a tcm_usb_gadget on a board with DWC3 UDC. > > When targetcli deb package was installed, a bunch of messages > > appeared, including this: > > > > [....] Fabric module tcm_usb_gadget is not loaded ... (warning). > > > > Any idea why is that? > > Comparing startup and running configs... > > Invalid fabric identifier 'usb_gadget': expected type 'loopback', > > 'iscsi', 'ib_srpt', 'vhost', 'tcm_fc', 'qla2xxx' > > > > Why is 'usb_gadget' fabric unknown? > > > > The gadget goes alive, I can list it on my Linux host, but I > > repeatedly get: > > > > [ 177.628876] g_target gadget: high-speed config #1: Linux Target > > [ 177.633411] Using the BOT protocol > > [ 198.459512] ERR bot_status_complete(64) > > [ 198.621077] g_target gadget: high-speed config #1: Linux Target > > [ 198.625607] Using the BOT protocol > > [ 219.451560] ERR bot_status_complete(64) > > ... > > > > Any ideas, why? > > I don't think the usb gadget fabric gets much use. There's no way to use > it or test it because a regular PC doesn't have the hardware to be a > downstream USB device. > Btw, it's possible to test using dummy_hcd. --nab -- To unsubscribe from this list: send the line "unsubscribe target-devel" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html