> Apologies for the delayed response, still catching up on post holiday > items.. > No issues. Nothing bad happened. :-) > In my experience with qla2xxx target mode on 25xx + 26xx series > hardware, I've never seen half-dupex mode negotiated using either > point-to-point or switched fabric configurations. > We're using qle2460 4 gbit adapters due to it's ultra low cost and while they seem to work very well then I am unable to get more than 270 MB/s out of them when doing storage vmotion. I should note that both storage arrays using target are certainly capable of delivering more than 400 MB/s when doing local tests e.g. dd copy. Obviously the expectation is to get the same over FC as you get locally. I did some tests from within VMware itself where a vm was running a benchmark tool that was reading and writing in different block sizes. This is the only time I've seen surpassing the 400 MB/s. However I am still unsure if I am really getting what is expected. Is there a way to verify in target or Linux overall what speed is set? Thank you. -- Henrik -- To unsubscribe from this list: send the line "unsubscribe target-devel" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
