From: Ludovic Desroches <ludovic.desroches@xxxxxxxxx> This patch has been added to the 3.12 stable tree. If you have any objections, please let us know. =============== commit a8d4e01637902311c5643b69a5c80e2805f04054 upstream. Maxburst was not set when doing the dma slave configuration. This value is checked by the recently introduced xdmac. It causes an error when doing the slave configuration and so prevents from using dma. Signed-off-by: Ludovic Desroches <ludovic.desroches@xxxxxxxxx> Acked-by: Nicolas Ferre <nicolas.ferre@xxxxxxxxx> Signed-off-by: Jiri Slaby <jslaby@xxxxxxx> --- drivers/tty/serial/atmel_serial.c | 2 ++ 1 file changed, 2 insertions(+) diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c index ebdc00f184a1..ab2e22bf54fd 100644 --- a/drivers/tty/serial/atmel_serial.c +++ b/drivers/tty/serial/atmel_serial.c @@ -756,6 +756,7 @@ static int atmel_prepare_tx_dma(struct uart_port *port) config.direction = DMA_MEM_TO_DEV; config.dst_addr_width = DMA_SLAVE_BUSWIDTH_1_BYTE; config.dst_addr = port->mapbase + ATMEL_US_THR; + config.dst_maxburst = 1; ret = dmaengine_device_control(atmel_port->chan_tx, DMA_SLAVE_CONFIG, @@ -920,6 +921,7 @@ static int atmel_prepare_rx_dma(struct uart_port *port) config.direction = DMA_DEV_TO_MEM; config.src_addr_width = DMA_SLAVE_BUSWIDTH_1_BYTE; config.src_addr = port->mapbase + ATMEL_US_RHR; + config.src_maxburst = 1; ret = dmaengine_device_control(atmel_port->chan_rx, DMA_SLAVE_CONFIG, -- 2.3.7 -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html