On 28/02/2015 10:01, Brian Norris wrote: > On Wed, Feb 18, 2015 at 11:32:07AM +0100, Maxime Ripard wrote: >> The NDDB register holds the data that are needed by the read and write >> commands. >> >> However, during a read PIO access, the datasheet specifies that after each 32 >> bytes read in that register, when BCH is enabled, we have to make sure that the >> RDDREQ bit is set in the NDSR register. >> >> This fixes an issue that was seen on the Armada 385, and presumably other mvebu >> SoCs, when a read on a newly erased page would end up in the driver reporting a >> timeout from the NAND. >> >> Cc: <stable@xxxxxxxxxxxxxxx> # v3.14 >> Signed-off-by: Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx> > > Pushed this one to linux-mtd.git. I'll try to get it out in the 4.0 > cycle. I assume patch 2 (the DT addition) will go through arm-soc. Yes, now that you took the driver part, I will apply it on mvebu and then push it to arm-soc. Thanks, Gregory > > Brian > -- Gregory Clement, Free Electrons Kernel, drivers, real-time and embedded Linux development, consulting, training and support. http://free-electrons.com -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html