From: Mikhail Rudenko <mike.rudenko@xxxxxxxxx> [ Upstream commit 5e53e4a66bc7430dd2d11c18a86410e3a38d2940 ] Currently, RK809's BUCK3 regulator is modelled in the driver as a configurable regulator with 0.5-2.4V voltage range. But the voltage setting is not actually applied, because when bit 6 of PMIC_POWER_CONFIG register is set to 0 (default), BUCK3 output voltage is determined by the external feedback resistor. Fix this, by setting bit 6 when voltage selection is set. Existing users which do not specify voltage constraints in their device trees will not be affected by this change, since no voltage setting is applied in those cases, and bit 6 is not enabled. Signed-off-by: Mikhail Rudenko <mike.rudenko@xxxxxxxxx> Link: https://patch.msgid.link/20241017-rk809-dcdc3-v1-1-e3c3de92f39c@xxxxxxxxx Signed-off-by: Mark Brown <broonie@xxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/regulator/rk808-regulator.c | 2 ++ 1 file changed, 2 insertions(+) diff --git a/drivers/regulator/rk808-regulator.c b/drivers/regulator/rk808-regulator.c index 14b60abd6afc6..01a8d04879184 100644 --- a/drivers/regulator/rk808-regulator.c +++ b/drivers/regulator/rk808-regulator.c @@ -1379,6 +1379,8 @@ static const struct regulator_desc rk809_reg[] = { .n_linear_ranges = ARRAY_SIZE(rk817_buck1_voltage_ranges), .vsel_reg = RK817_BUCK3_ON_VSEL_REG, .vsel_mask = RK817_BUCK_VSEL_MASK, + .apply_reg = RK817_POWER_CONFIG, + .apply_bit = RK817_BUCK3_FB_RES_INTER, .enable_reg = RK817_POWER_EN_REG(0), .enable_mask = ENABLE_MASK(RK817_ID_DCDC3), .enable_val = ENABLE_MASK(RK817_ID_DCDC3), -- 2.43.0
