When running "xdp-bench tx eno0" to test the XDP_TX feature of ENETC on LS1028A, it was found that if the command was re-run multiple times, Rx could not receive the frames, and the result of xdo-bench showed that the rx rate was 0. root@ls1028ardb:~# ./xdp-bench tx eno0 Hairpinning (XDP_TX) packets on eno0 (ifindex 3; driver fsl_enetc) Summary 2046 rx/s 0 err,drop/s Summary 0 rx/s 0 err,drop/s Summary 0 rx/s 0 err,drop/s Summary 0 rx/s 0 err,drop/s By observing the Rx PIR and CIR registers, we found that CIR is always equal to 0x7FF and PIR is always 0x7FE, which means that the Rx ring is full and can no longer accommodate other Rx frames. Therefore, we can conclude that the problem is caused by the Rx BD ring not being cleaned up. Further analysis of the code revealed that the Rx BD ring will only be cleaned if the "cleaned_cnt > xdp_tx_in_flight" condition is met. Therefore, some debug logs were added to the driver and the current values of cleaned_cnt and xdp_tx_in_flight were printed when the Rx BD ring was full. The logs are as follows. [ 178.762419] [XDP TX] >> cleaned_cnt:1728, xdp_tx_in_flight:2140 [ 178.771387] [XDP TX] >> cleaned_cnt:1941, xdp_tx_in_flight:2110 [ 178.776058] [XDP TX] >> cleaned_cnt:1792, xdp_tx_in_flight:2110
