pm_runtime_enable() should happen prior to vfe_get() since vfe_get() calls
pm_runtime_resume_and_get().
This is a basic race condition that doesn't show up for most users so is
not widely reported. If you blacklist qcom-camss in modules.d and then
subsequently modprobe the module post-boot it is possible to reliably show
this error up.
The kernel log for this error looks like this:
qcom-camss ac5a000.camss: Failed to power up pipeline: -13
Fixes: 02afa816dbbf ("media: camss: Add basic runtime PM support")
Reported-by: Johan Hovold <johan+linaro@xxxxxxxxxx>
Closes: https://lore.kernel.org/lkml/ZoVNHOTI0PKMNt4_@xxxxxxxxxxxxxxxxxxxx/
Tested-by: Johan Hovold <johan+linaro@xxxxxxxxxx>
Cc: <stable@xxxxxxxxxxxxxxx>
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
Reviewed-by: Konrad Dybcio <konradybcio@xxxxxxxxxx>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xxxxxxxxx>
diff --git a/drivers/media/platform/qcom/camss/camss.c b/drivers/media/platform/qcom/camss/camss.c
index 51b1d3550421..d64985ca6e88 100644
--- a/drivers/media/platform/qcom/camss/camss.c
+++ b/drivers/media/platform/qcom/camss/camss.c
@@ -2283,6 +2283,8 @@ static int camss_probe(struct platform_device *pdev)
v4l2_async_nf_init(&camss->notifier, &camss->v4l2_dev);
+ pm_runtime_enable(dev);
+
num_subdevs = camss_of_parse_ports(camss);
if (num_subdevs < 0) {
ret = num_subdevs;
@@ -2323,8 +2325,6 @@ static int camss_probe(struct platform_device *pdev)
}
}
- pm_runtime_enable(dev);
-
return 0;
err_register_subdevs:
@@ -2332,6 +2332,7 @@ static int camss_probe(struct platform_device *pdev)
err_v4l2_device_unregister:
v4l2_device_unregister(&camss->v4l2_dev);
v4l2_async_nf_cleanup(&camss->notifier);
+ pm_runtime_disable(dev);
err_genpd_cleanup:
camss_genpd_cleanup(camss);
