From: Michal Vokáč <michal.vokac@xxxxxxxxx>
[ Upstream commit 023bd910d3ab735459f84b22bb99fb9e00bd9d76 ]
This change does not have any functional effect. The switch works just
fine without this patch as it has full access to all the addresses
on the bus. This is simply a clean-up to set the node name address
and reg address to the same value.
Fixes: 15b43e497ffd ("ARM: dts: imx6dl-yapp4: Use correct pseudo PHY address for the switch")
Signed-off-by: Michal Vokáč <michal.vokac@xxxxxxxxx>
Reviewed-by: Andrew Lunn <andrew@xxxxxxx>
Signed-off-by: Shawn Guo <shawnguo@xxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
arch/arm/boot/dts/imx6dl-yapp4-common.dtsi | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi b/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi
index cb1972f8e8d27..a655b945bf2df 100644
--- a/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi
+++ b/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi
@@ -128,7 +128,7 @@ phy_port3: phy@2 {
switch@10 {
compatible = "qca,qca8334";
- reg = <10>;
+ reg = <0x10>;
reset-gpios = <&gpio1 25 GPIO_ACTIVE_LOW>;
switch_ports: ports {
--
2.43.0
