Re: [PATCH v1] i2c: designware: Disable TX_EMPTY irq while waiting for block length byte

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 10/3/2023 15:57, Andy Shevchenko wrote:
On Fri, Sep 29, 2023 at 10:53:56AM +0700, Tam Nguyen wrote:
During SMBus block data read process, we have seen high interrupt rate
because of TX_EMPTY irq status while waiting for block length byte (the
first data byte after the address phase). The interrupt handler does not
do anything because the internal state is kept as STATUS_WRITE_IN_PROGRESS.
Hence, we should disable TX_EMPTY irq until I2C DW receives first data
IRQ
DesignWare
Got that. I will update in V2.
byte from I2C device, then re-enable it.

It takes 0.789 ms for host to receive data length from slave.
Without the patch, i2c_dw_isr is called 99 times by TX_EMPTY interrupt.
i2c_dw_isr()
Will update in V2.

And it is none after applying the patch.
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Chuong Tran <chuong@xxxxxxxxxxxxxxxxxxxxxx>
Who is this guy? Do you need Co-developed-by tag?
Right, that's my bad. I will update it with "Co-developed-by" tag
Signed-off-by: Tam Nguyen <tamnguyenchi@xxxxxxxxxxxxxxxxxxxxxx>
Other than that, agree with Serge's points.
Thanks both of you. I totally agree with Serge's points and will update them in v2.




[Index of Archives]     [Linux Kernel]     [Kernel Development Newbies]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Hiking]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux