Re: [PATCH v2] Revert "usb: dwc3: core: Enable AutoRetry feature in the controller"

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, Jul 13, 2023, Jakub Vanek wrote:
> This reverts commit b138e23d3dff90c0494925b4c1874227b81bddf7.
> 
> AutoRetry has been found to cause some issues. This feature allows
> the controller in host mode (further referred to as the xHC) to send
> non-terminating/burst retry ACKs (Retry=1 and Nump!=0) instead of
> terminating retry ACKs (Retry=1 and Nump=0) to devices when
> a transaction error occurs.
> 
> Unfortunately, some USB devices fail to retry transactions when
> the xHC sends them a burst retry ACK. When this happens, the xHC

For some clarity: if the device continues to respond with CRC error,
the xHC will not complete endpoint related commands while it keeps
autoretry.

> enters a strange state. After the affected transfer times out,
> the xHCI driver tries to resume normal operation of the xHC
> by sending it a Stop Endpoint command. However, the xHC fails
> to respond to it, and the xHCI driver gives up. [1]
> This fact is reported via dmesg:
> 
> [sda] tag#29 uas_eh_abort_handler 0 uas-tag 1 inflight: CMD IN
> [sda] tag#29 CDB: opcode=0x28 28 00 00 69 42 80 00 00 48 00
> xhci-hcd: xHCI host not responding to stop endpoint command
> xhci-hcd: xHCI host controller not responding, assume dead
> xhci-hcd: HC died; cleaning up
> 
> Some users observed this problem on an Odroid HC2 with the JMS578
> USB3-to-SATA bridge. The issue can be triggered by starting
> a read-heavy workload on an attached SSD. After a while, the host
> controller would die and the SSD would disappear from the system. [1]
> 
> Further analysis by Synopsys determined that controller revisions
> other than the one in Odroid HC2 are also affected by this.
> The recommended solution was to disable AutoRetry altogether.
> This change does not have a noticeable performance impact. [2]
> 
> Fixes: b138e23d3dff ("usb: dwc3: core: Enable AutoRetry feature in the controller")
> Link: https://urldefense.com/v3/__https://lore.kernel.org/r/a21f34c04632d250cd0a78c7c6f4a1c9c7a43142.camel@xxxxxxxxx/__;!!A4F2R9G_pg!aCe0isNmX63t6ILE2Tv2cX4UnrpDFo6LXWb6oS3-OYFYfX88igrfqmW4Z8UdO7sWz0mdco6vbBrR_KMzYaccpLF7Kw$  [1]
> Link: https://urldefense.com/v3/__https://lore.kernel.org/r/20230711214834.kyr6ulync32d4ktk@xxxxxxxxxxxx/__;!!A4F2R9G_pg!aCe0isNmX63t6ILE2Tv2cX4UnrpDFo6LXWb6oS3-OYFYfX88igrfqmW4Z8UdO7sWz0mdco6vbBrR_KMzYae75T8GCw$  [2]
> Cc: stable@xxxxxxxxxxxxxxx
> Cc: Mauro Ribeiro <mauro.ribeiro@xxxxxxxxxxxxxx>
> Cc: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
> Suggested-by: Thinh Nguyen <Thinh.Nguyen@xxxxxxxxxxxx>
> Signed-off-by: Jakub Vanek <linuxtardis@xxxxxxxxx>
> ---
> V1 -> V2: Updated to disable AutoRetry everywhere based on Synopsys feedback
>           Reworded the changelog a bit to make it clearer
> 
>  drivers/usb/dwc3/core.c | 16 ----------------
>  drivers/usb/dwc3/core.h |  3 ---
>  2 files changed, 19 deletions(-)
> 
> diff --git a/drivers/usb/dwc3/core.c b/drivers/usb/dwc3/core.c
> index f6689b731718..a4e079d37566 100644
> --- a/drivers/usb/dwc3/core.c
> +++ b/drivers/usb/dwc3/core.c
> @@ -1209,22 +1209,6 @@ static int dwc3_core_init(struct dwc3 *dwc)
>  		dwc3_writel(dwc->regs, DWC3_GUCTL1, reg);
>  	}
>  
> -	if (dwc->dr_mode == USB_DR_MODE_HOST ||
> -	    dwc->dr_mode == USB_DR_MODE_OTG) {
> -		reg = dwc3_readl(dwc->regs, DWC3_GUCTL);
> -
> -		/*
> -		 * Enable Auto retry Feature to make the controller operating in
> -		 * Host mode on seeing transaction errors(CRC errors or internal
> -		 * overrun scenerios) on IN transfers to reply to the device
> -		 * with a non-terminating retry ACK (i.e, an ACK transcation
> -		 * packet with Retry=1 & Nump != 0)
> -		 */
> -		reg |= DWC3_GUCTL_HSTINAUTORETRY;
> -
> -		dwc3_writel(dwc->regs, DWC3_GUCTL, reg);
> -	}
> -
>  	/*
>  	 * Must config both number of packets and max burst settings to enable
>  	 * RX and/or TX threshold.
> diff --git a/drivers/usb/dwc3/core.h b/drivers/usb/dwc3/core.h
> index 8b1295e4dcdd..a69ac67d89fe 100644
> --- a/drivers/usb/dwc3/core.h
> +++ b/drivers/usb/dwc3/core.h
> @@ -256,9 +256,6 @@
>  #define DWC3_GCTL_GBLHIBERNATIONEN	BIT(1)
>  #define DWC3_GCTL_DSBLCLKGTNG		BIT(0)
>  
> -/* Global User Control Register */
> -#define DWC3_GUCTL_HSTINAUTORETRY	BIT(14)
> -
>  /* Global User Control 1 Register */
>  #define DWC3_GUCTL1_DEV_DECOUPLE_L1L2_EVT	BIT(31)
>  #define DWC3_GUCTL1_TX_IPGAP_LINECHECK_DIS	BIT(28)
> -- 
> 2.25.1
> 

Acked-by: Thinh Nguyen <Thinh.Nguyen@xxxxxxxxxxxx>

Thanks,
Thinh




[Index of Archives]     [Linux Kernel]     [Kernel Development Newbies]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Hiking]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux