From: Vladimir Oltean <vladimir.oltean@xxxxxxx> [ Upstream commit 6d6af5796e5d9a88ae83c9c753023bba61deb18b ] This variable has been present since the initial submission of the driver, and held, for some reason, the value of zero, to be sent on the wire in the case there wasn't any TX buffer for the current transfer. Since quite a while now, however, it isn't doing anything at all. Signed-off-by: Vladimir Oltean <vladimir.oltean@xxxxxxx> Link: https://lore.kernel.org/r/20200304220044.11193-3-olteanv@xxxxxxxxx Signed-off-by: Mark Brown <broonie@xxxxxxxxxx> Stable-dep-of: c5c31fb71f16 ("spi: fsl-dspi: avoid SCK glitches with continuous transfers") Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/spi/spi-fsl-dspi.c | 6 ------ 1 file changed, 6 deletions(-) diff --git a/drivers/spi/spi-fsl-dspi.c b/drivers/spi/spi-fsl-dspi.c index 3e0200618af30..51e17f0828646 100644 --- a/drivers/spi/spi-fsl-dspi.c +++ b/drivers/spi/spi-fsl-dspi.c @@ -121,7 +121,6 @@ struct chip_data { u32 ctar_val; - u16 void_write_data; }; enum dspi_trans_mode { @@ -190,7 +189,6 @@ struct fsl_dspi { const void *tx; void *rx; void *rx_end; - u16 void_write_data; u16 tx_cmd; u8 bits_per_word; u8 bytes_per_word; @@ -748,8 +746,6 @@ static int dspi_transfer_one_message(struct spi_controller *ctlr, dspi->tx_cmd |= SPI_PUSHR_CMD_CONT; } - dspi->void_write_data = dspi->cur_chip->void_write_data; - dspi->tx = transfer->tx_buf; dspi->rx = transfer->rx_buf; dspi->rx_end = dspi->rx + transfer->len; @@ -848,8 +844,6 @@ static int dspi_setup(struct spi_device *spi) sck_cs_delay = pdata->sck_cs_delay; } - chip->void_write_data = 0; - clkrate = clk_get_rate(dspi->clk); hz_to_spi_baud(&pbr, &br, spi->max_speed_hz, clkrate); -- 2.39.2
