From: Mario Limonciello <mario.limonciello@xxxxxxx>
commit 2a821fc3136d5d99dcb9de152be8a052ca27d870 upstream.
Donghun reports that a notebook that has an AMD Ryzen 5700U but supports
S3 has problems with USB after resuming from suspend. The issue was
bisected down to commit d1658268e439 ("usb: pci-quirks: disable D3cold on
xhci suspend for s2idle on AMD Renoir").
As this issue only happens on S3, narrow the broken D3cold quirk to only
run in s2idle.
Fixes: d1658268e439 ("usb: pci-quirks: disable D3cold on xhci suspend for s2idle on AMD Renoir")
Reported-and-tested-by: Donghun Yoon <donghun.yoon@xxxxxxx>
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Mario Limonciello <mario.limonciello@xxxxxxx>
Signed-off-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx>
Link: https://lore.kernel.org/r/20230515134059.161110-2-mathias.nyman@xxxxxxxxxxxxxxx
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/usb/host/xhci-pci.c | 12 ++++++++++--
drivers/usb/host/xhci.h | 2 +-
2 files changed, 11 insertions(+), 3 deletions(-)
--- a/drivers/usb/host/xhci-pci.c
+++ b/drivers/usb/host/xhci-pci.c
@@ -13,6 +13,7 @@
#include <linux/module.h>
#include <linux/acpi.h>
#include <linux/reset.h>
+#include <linux/suspend.h>
#include "xhci.h"
#include "xhci-trace.h"
@@ -195,7 +196,7 @@ static void xhci_pci_quirks(struct devic
if (pdev->vendor == PCI_VENDOR_ID_AMD &&
pdev->device == PCI_DEVICE_ID_AMD_RENOIR_XHCI)
- xhci->quirks |= XHCI_BROKEN_D3COLD;
+ xhci->quirks |= XHCI_BROKEN_D3COLD_S2I;
if (pdev->vendor == PCI_VENDOR_ID_INTEL) {
xhci->quirks |= XHCI_LPM_SUPPORT;
@@ -610,9 +611,16 @@ static int xhci_pci_suspend(struct usb_h
* Systems with the TI redriver that loses port status change events
* need to have the registers polled during D3, so avoid D3cold.
*/
- if (xhci->quirks & (XHCI_COMP_MODE_QUIRK | XHCI_BROKEN_D3COLD))
+ if (xhci->quirks & XHCI_COMP_MODE_QUIRK)
pci_d3cold_disable(pdev);
+#ifdef CONFIG_SUSPEND
+ /* d3cold is broken, but only when s2idle is used */
+ if (pm_suspend_target_state == PM_SUSPEND_TO_IDLE &&
+ xhci->quirks & (XHCI_BROKEN_D3COLD_S2I))
+ pci_d3cold_disable(pdev);
+#endif
+
if (xhci->quirks & XHCI_PME_STUCK_QUIRK)
xhci_pme_quirk(hcd);
--- a/drivers/usb/host/xhci.h
+++ b/drivers/usb/host/xhci.h
@@ -1902,7 +1902,7 @@ struct xhci_hcd {
#define XHCI_DISABLE_SPARSE BIT_ULL(38)
#define XHCI_SG_TRB_CACHE_SIZE_QUIRK BIT_ULL(39)
#define XHCI_NO_SOFT_RETRY BIT_ULL(40)
-#define XHCI_BROKEN_D3COLD BIT_ULL(41)
+#define XHCI_BROKEN_D3COLD_S2I BIT_ULL(41)
#define XHCI_EP_CTX_BROKEN_DCS BIT_ULL(42)
#define XHCI_SUSPEND_RESUME_CLKS BIT_ULL(43)
#define XHCI_RESET_TO_DEFAULT BIT_ULL(44)
