Even if a gpio pin is set to output, we still need to set INPUT_EN bit to be able to read its value. Without this change, we'll always read low level state. Cc: <stable@xxxxxxxxxxxxxxx> # v3.14+ Signed-off-by: David Cohen <david.a.cohen@xxxxxxxxxxxxxxx> --- Hi, I'm resending same v1 patch but now copying linux stable and linux gpio. This patch is meant for all linux stable trees >= v3.14. Br, David --- drivers/pinctrl/pinctrl-baytrail.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/pinctrl/pinctrl-baytrail.c b/drivers/pinctrl/pinctrl-baytrail.c index e12e5b07f6d7..c23d8ded936d 100644 --- a/drivers/pinctrl/pinctrl-baytrail.c +++ b/drivers/pinctrl/pinctrl-baytrail.c @@ -318,7 +318,7 @@ static int byt_gpio_direction_output(struct gpio_chip *chip, "Potential Error: Setting GPIO with direct_irq_en to output"); reg_val = readl(reg) | BYT_DIR_MASK; - reg_val &= ~BYT_OUTPUT_EN; + reg_val &= ~(BYT_OUTPUT_EN | BYT_INPUT_EN); if (value) writel(reg_val | BYT_LEVEL, reg); -- 2.1.0 -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html