3.10-stable review patch. If anyone has any objections, please let me know.
------------------
From: Shen Guang <shenguang10@xxxxxxxxx>
commit 08d1dec6f4054e3613f32051d9b149d4203ce0d2 upstream.
When we are doing compliance test with xHCI, we found that if we
enable CONFIG_USB_SUSPEND and plug in a bad device which causes
over-current condition to the root port, software will not be noticed.
The reason is that current code don't set hub->change_bits in
hub_activate() when over-current happens, and then hub_events() will
not check the port status because it thinks nothing changed.
If CONFIG_USB_SUSPEND is disabled, the interrupt pipe of the hub will
report the change and set hub->event_bits, and then hub_events() will
check what events happened.In this case over-current can be detected.
Signed-off-by: Shen Guang <shenguang10@xxxxxxxxx>
Acked-by: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
Acked-by: Sarah Sharp <sarah.a.sharp@xxxxxxxxxxxxxxx>
Cc: Frans Klaver <fransklaver@xxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/usb/core/hub.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -1165,7 +1165,8 @@ static void hub_activate(struct usb_hub
/* Tell khubd to disconnect the device or
* check for a new connection
*/
- if (udev || (portstatus & USB_PORT_STAT_CONNECTION))
+ if (udev || (portstatus & USB_PORT_STAT_CONNECTION) ||
+ (portstatus & USB_PORT_STAT_OVERCURRENT))
set_bit(port1, hub->change_bits);
} else if (portstatus & USB_PORT_STAT_ENABLE) {
--
To unsubscribe from this list: send the line "unsubscribe stable" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html