Currently, when resetting the USB modem via AT commands, the modem is
no longer re-connected.
This problem is caused by the incorrect description of the USB_OTG2_OC
pad. It should have pull-up enabled, hysteresis enabled and the
property 'over-current-active-low' should be passed.
With this change, the USB modem can be successfully re-connected
after a reset.
Cc: stable@xxxxxxxxxxxxxxx
Fixes: 9ac0ae97e349 ("ARM: dts: imx7d-smegw01: Add support for i.MX7D SMEGW01 board")
Signed-off-by: Fabio Estevam <festevam@xxxxxxx>
---
arch/arm/boot/dts/imx7d-smegw01.dts | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/imx7d-smegw01.dts b/arch/arm/boot/dts/imx7d-smegw01.dts
index 546268b8d0b1..c0f00f5db11e 100644
--- a/arch/arm/boot/dts/imx7d-smegw01.dts
+++ b/arch/arm/boot/dts/imx7d-smegw01.dts
@@ -198,6 +198,7 @@ &usbotg1 {
&usbotg2 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_usbotg2>;
+ over-current-active-low;
dr_mode = "host";
status = "okay";
};
@@ -374,7 +375,7 @@ MX7D_PAD_LPSR_GPIO1_IO05__GPIO1_IO5 0x04
pinctrl_usbotg2: usbotg2grp {
fsl,pins = <
- MX7D_PAD_UART3_RTS_B__USB_OTG2_OC 0x04
+ MX7D_PAD_UART3_RTS_B__USB_OTG2_OC 0x5c
>;
};
--
2.25.1
