On Thu, Sep 25, 2014 at 11:19:51AM +0200, Frans Klaver wrote: > If the chosen baud rate is large enough (e.g. 3.5 megabaud), the > calculated n values in serial_omap_is_baud_mode16() may become 0. This > causes a division by zero when calculating the difference between > calculated and desired baud rates. To prevent this, cap the n13 and n16 > values on 1. > > Division by zero in kernel. > [<c00132e0>] (unwind_backtrace) from [<c00112ec>] (show_stack+0x10/0x14) > [<c00112ec>] (show_stack) from [<c01ed7bc>] (Ldiv0+0x8/0x10) > [<c01ed7bc>] (Ldiv0) from [<c023805c>] (serial_omap_baud_is_mode16+0x4c/0x68) > [<c023805c>] (serial_omap_baud_is_mode16) from [<c02396b4>] (serial_omap_set_termios+0x90/0x8d8) > [<c02396b4>] (serial_omap_set_termios) from [<c0230a0c>] (uart_change_speed+0xa4/0xa8) > [<c0230a0c>] (uart_change_speed) from [<c0231798>] (uart_set_termios+0xa0/0x1fc) > [<c0231798>] (uart_set_termios) from [<c022bb44>] (tty_set_termios+0x248/0x2c0) > [<c022bb44>] (tty_set_termios) from [<c022c17c>] (set_termios+0x248/0x29c) > [<c022c17c>] (set_termios) from [<c022c3e4>] (tty_mode_ioctl+0x1c8/0x4e8) > [<c022c3e4>] (tty_mode_ioctl) from [<c0227e70>] (tty_ioctl+0xa94/0xb18) > [<c0227e70>] (tty_ioctl) from [<c00cf45c>] (do_vfs_ioctl+0x4a0/0x560) > [<c00cf45c>] (do_vfs_ioctl) from [<c00cf568>] (SyS_ioctl+0x4c/0x74) > [<c00cf568>] (SyS_ioctl) from [<c000e480>] (ret_fast_syscall+0x0/0x30) > > Signed-off-by: Frans Klaver <frans.klaver@xxxxxxxxx> > --- > Resend to add stable@xxxxxxxxxxxxxxx to CC. As far as I know, this applies to > v3.9 and up. <formletter> This is not the correct way to submit patches for inclusion in the stable kernel tree. Please read Documentation/stable_kernel_rules.txt for how to do this properly. </formletter> I'll take care of this, but go read that file for your next time... greg k-h -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html