From: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
[ Upstream commit ec5dba73f7ba10797904cf18092d2e6975a22147 ]
The shutdown GPIO is active low (SD_N), but this depends on actual board
layout. Linux drivers should only care about logical state, where high
(1) means shutdown and low (0) means do not shutdown.
Invert the GPIO to match logical value.
Fixes: 43b8c7dc85a1 ("ASoC: codecs: add wsa883x amplifier support")
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
Reviewed-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
Link: https://lore.kernel.org/r/20221110133512.478831-2-krzysztof.kozlowski@xxxxxxxxxx
Signed-off-by: Mark Brown <broonie@xxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
sound/soc/codecs/wsa883x.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/sound/soc/codecs/wsa883x.c b/sound/soc/codecs/wsa883x.c
index 63e1d7aa6137..cb1d0a3e90e6 100644
--- a/sound/soc/codecs/wsa883x.c
+++ b/sound/soc/codecs/wsa883x.c
@@ -1393,7 +1393,7 @@ static int wsa883x_probe(struct sdw_slave *pdev,
}
wsa883x->sd_n = devm_gpiod_get_optional(&pdev->dev, "powerdown",
- GPIOD_FLAGS_BIT_NONEXCLUSIVE);
+ GPIOD_FLAGS_BIT_NONEXCLUSIVE | GPIOD_OUT_HIGH);
if (IS_ERR(wsa883x->sd_n)) {
dev_err(&pdev->dev, "Shutdown Control GPIO not found\n");
ret = PTR_ERR(wsa883x->sd_n);
@@ -1411,7 +1411,7 @@ static int wsa883x_probe(struct sdw_slave *pdev,
pdev->prop.sink_ports = GENMASK(WSA883X_MAX_SWR_PORTS, 0);
pdev->prop.sink_dpn_prop = wsa_sink_dpn_prop;
pdev->prop.scp_int1_mask = SDW_SCP_INT1_BUS_CLASH | SDW_SCP_INT1_PARITY;
- gpiod_direction_output(wsa883x->sd_n, 1);
+ gpiod_direction_output(wsa883x->sd_n, 0);
wsa883x->regmap = devm_regmap_init_sdw(pdev, &wsa883x_regmap_config);
if (IS_ERR(wsa883x->regmap)) {
--
2.35.1
