From: Oleksandr Shamray <oleksandrs@xxxxxxxxxx>
[ Upstream commit 525dd5aed67a2f4f7278116fb92a24e6a53e2622 ]
Fix scale factors for reading MPS Multi-phase mp2888 controller.
Fixed sensors:
- PIN/POUT: based on vendor documentation, set bscale factor 0.5W/LSB
- IOUT: based on vendor documentation, set scale factor 0.25 A/LSB
Fixes: e4db7719d037 ("hwmon: (pmbus) Add support for MPS Multi-phase mp2888 controller")
Signed-off-by: Oleksandr Shamray <oleksandrs@xxxxxxxxxx>
Reviewed-by: Vadim Pasternak <vadimp@xxxxxxxxxx>
Link: https://lore.kernel.org/r/20220929121642.63051-1-oleksandrs@xxxxxxxxxx
Signed-off-by: Guenter Roeck <linux@xxxxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
drivers/hwmon/pmbus/mp2888.c | 13 ++++++-------
1 file changed, 6 insertions(+), 7 deletions(-)
diff --git a/drivers/hwmon/pmbus/mp2888.c b/drivers/hwmon/pmbus/mp2888.c
index 8ecd4adfef40..24e5194706cf 100644
--- a/drivers/hwmon/pmbus/mp2888.c
+++ b/drivers/hwmon/pmbus/mp2888.c
@@ -34,7 +34,7 @@ struct mp2888_data {
int curr_sense_gain;
};
-#define to_mp2888_data(x) container_of(x, struct mp2888_data, info)
+#define to_mp2888_data(x) container_of(x, struct mp2888_data, info)
static int mp2888_read_byte_data(struct i2c_client *client, int page, int reg)
{
@@ -109,7 +109,7 @@ mp2888_read_phase(struct i2c_client *client, struct mp2888_data *data, int page,
* - Kcs is the DrMOS current sense gain of power stage, which is obtained from the
* register MP2888_MFR_VR_CONFIG1, bits 13-12 with the following selection of DrMOS
* (data->curr_sense_gain):
- * 00b - 5µA/A, 01b - 8.5µA/A, 10b - 9.7µA/A, 11b - 10µA/A.
+ * 00b - 8.5µA/A, 01b - 9.7µA/A, 1b - 10µA/A, 11b - 5µA/A.
* - Rcs is the internal phase current sense resistor. This parameter depends on hardware
* assembly. By default it is set to 1kΩ. In case of different assembly, user should
* scale this parameter by dividing it by Rcs.
@@ -118,10 +118,9 @@ mp2888_read_phase(struct i2c_client *client, struct mp2888_data *data, int page,
* because sampling of current occurrence of bit weight has a big deviation, especially for
* light load.
*/
- ret = DIV_ROUND_CLOSEST(ret * 100 - 9800, data->curr_sense_gain);
- ret = (data->phase_curr_resolution) ? ret * 2 : ret;
+ ret = DIV_ROUND_CLOSEST(ret * 200 - 19600, data->curr_sense_gain);
/* Scale according to total current resolution. */
- ret = (data->total_curr_resolution) ? ret * 8 : ret * 4;
+ ret = (data->total_curr_resolution) ? ret * 2 : ret;
return ret;
}
@@ -212,7 +211,7 @@ static int mp2888_read_word_data(struct i2c_client *client, int page, int phase,
ret = pmbus_read_word_data(client, page, phase, reg);
if (ret < 0)
return ret;
- ret = data->total_curr_resolution ? ret * 2 : ret;
+ ret = data->total_curr_resolution ? ret : DIV_ROUND_CLOSEST(ret, 2);
break;
case PMBUS_POUT_OP_WARN_LIMIT:
ret = pmbus_read_word_data(client, page, phase, reg);
@@ -223,7 +222,7 @@ static int mp2888_read_word_data(struct i2c_client *client, int page, int phase,
* set 1. Actual power is reported with 0.5W or 1W respectively resolution. Scaling
* is needed to match both.
*/
- ret = data->total_curr_resolution ? ret * 4 : ret * 2;
+ ret = data->total_curr_resolution ? ret * 2 : ret;
break;
/*
* The below registers are not implemented by device or implemented not according to the
--
2.35.1
