From: Anssi Hannula <anssi.hannula@xxxxxxxxxx>
kvaser_usb uses completions to signal when a response event is received
for outgoing commands.
However, it uses init_completion() to reinitialize the start_comp and
stop_comp completions before sending the start/stop commands.
In case the device sends the corresponding response just before the
actual command is sent, complete() may be called concurrently with
init_completion() which is not safe.
This might be triggerable even with a properly functioning device by
stopping the interface (CMD_STOP_CHIP) just after it goes bus-off (which
also causes the driver to send CMD_STOP_CHIP when restart-ms is off),
but that was not tested.
Fix the issue by using reinit_completion() instead.
Cc: stable@xxxxxxxxxxxxxxx
Fixes: 080f40a6fa28 ("can: kvaser_usb: Add support for Kvaser CAN/USB devices")
Tested-by: Jimmy Assarsson <extja@xxxxxxxxxx>
Signed-off-by: Anssi Hannula <anssi.hannula@xxxxxxxxxx>
Signed-off-by: Jimmy Assarsson <extja@xxxxxxxxxx>
---
Changes in v4:
- No changes
Changes in v3:
- Rebased on 1d5eeda23f36 ("can: kvaser_usb: advertise timestamping capabilities and add ioctl support")
- Add stable to CC
- Add S-o-b
Changes in v2:
- Rebased on b3b6df2c56d8 ("can: kvaser_usb: kvaser_usb_leaf: fix bittiming limits")
drivers/net/can/usb/kvaser_usb/kvaser_usb_hydra.c | 4 ++--
drivers/net/can/usb/kvaser_usb/kvaser_usb_leaf.c | 4 ++--
2 files changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/net/can/usb/kvaser_usb/kvaser_usb_hydra.c b/drivers/net/can/usb/kvaser_usb/kvaser_usb_hydra.c
index 3dcd35979e6f..3abfaa77e893 100644
--- a/drivers/net/can/usb/kvaser_usb/kvaser_usb_hydra.c
+++ b/drivers/net/can/usb/kvaser_usb/kvaser_usb_hydra.c
@@ -1875,7 +1875,7 @@ static int kvaser_usb_hydra_start_chip(struct kvaser_usb_net_priv *priv)
{
int err;
- init_completion(&priv->start_comp);
+ reinit_completion(&priv->start_comp);
err = kvaser_usb_hydra_send_simple_cmd(priv->dev, CMD_START_CHIP_REQ,
priv->channel);
@@ -1893,7 +1893,7 @@ static int kvaser_usb_hydra_stop_chip(struct kvaser_usb_net_priv *priv)
{
int err;
- init_completion(&priv->stop_comp);
+ reinit_completion(&priv->stop_comp);
/* Make sure we do not report invalid BUS_OFF from CMD_CHIP_STATE_EVENT
* see comment in kvaser_usb_hydra_update_state()
diff --git a/drivers/net/can/usb/kvaser_usb/kvaser_usb_leaf.c b/drivers/net/can/usb/kvaser_usb/kvaser_usb_leaf.c
index 8e11cda85624..9683bc5e8257 100644
--- a/drivers/net/can/usb/kvaser_usb/kvaser_usb_leaf.c
+++ b/drivers/net/can/usb/kvaser_usb/kvaser_usb_leaf.c
@@ -1320,7 +1320,7 @@ static int kvaser_usb_leaf_start_chip(struct kvaser_usb_net_priv *priv)
{
int err;
- init_completion(&priv->start_comp);
+ reinit_completion(&priv->start_comp);
err = kvaser_usb_leaf_send_simple_cmd(priv->dev, CMD_START_CHIP,
priv->channel);
@@ -1338,7 +1338,7 @@ static int kvaser_usb_leaf_stop_chip(struct kvaser_usb_net_priv *priv)
{
int err;
- init_completion(&priv->stop_comp);
+ reinit_completion(&priv->stop_comp);
err = kvaser_usb_leaf_send_simple_cmd(priv->dev, CMD_STOP_CHIP,
priv->channel);
--
2.37.3
