From: Samuel Holland <samuel@xxxxxxxxxxxx>
commit fc153c8f283bf5925615195fc9d4056414d7b168 upstream.
H6 requires I/O bias configuration on both of its PIO devices.
Previously it was only done for the main PIO.
The setting for Port L is at bit 0, so the bank calculation needs to
account for the pin base. Otherwise the wrong bit is used.
Fixes: cc62383fcebe ("pinctrl: sunxi: Support I/O bias voltage setting on H6")
Reviewed-by: Jernej Skrabec <jernej.skrabec@xxxxxxxxx>
Tested-by: Heiko Stuebner <heiko@xxxxxxxxx>
Signed-off-by: Samuel Holland <samuel@xxxxxxxxxxxx>
Link: https://lore.kernel.org/r/20220713025233.27248-3-samuel@xxxxxxxxxxxx
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/pinctrl/sunxi/pinctrl-sun50i-h6-r.c | 1 +
drivers/pinctrl/sunxi/pinctrl-sunxi.c | 7 ++++---
2 files changed, 5 insertions(+), 3 deletions(-)
--- a/drivers/pinctrl/sunxi/pinctrl-sun50i-h6-r.c
+++ b/drivers/pinctrl/sunxi/pinctrl-sun50i-h6-r.c
@@ -105,6 +105,7 @@ static const struct sunxi_pinctrl_desc s
.npins = ARRAY_SIZE(sun50i_h6_r_pins),
.pin_base = PL_BASE,
.irq_banks = 2,
+ .io_bias_cfg_variant = BIAS_VOLTAGE_PIO_POW_MODE_SEL,
};
static int sun50i_h6_r_pinctrl_probe(struct platform_device *pdev)
--- a/drivers/pinctrl/sunxi/pinctrl-sunxi.c
+++ b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
@@ -616,7 +616,7 @@ static int sunxi_pinctrl_set_io_bias_cfg
unsigned pin,
struct regulator *supply)
{
- unsigned short bank = pin / PINS_PER_BANK;
+ unsigned short bank;
unsigned long flags;
u32 val, reg;
int uV;
@@ -632,6 +632,9 @@ static int sunxi_pinctrl_set_io_bias_cfg
if (uV == 0)
return 0;
+ pin -= pctl->desc->pin_base;
+ bank = pin / PINS_PER_BANK;
+
switch (pctl->desc->io_bias_cfg_variant) {
case BIAS_VOLTAGE_GRP_CONFIG:
/*
@@ -649,8 +652,6 @@ static int sunxi_pinctrl_set_io_bias_cfg
else
val = 0xD; /* 3.3V */
- pin -= pctl->desc->pin_base;
-
reg = readl(pctl->membase + sunxi_grp_config_reg(pin));
reg &= ~IO_BIAS_MASK;
writel(reg | val, pctl->membase + sunxi_grp_config_reg(pin));
