The patch below does not apply to the 5.10-stable tree.
If someone wants it applied there, or to any other stable or longterm
tree, then please email the backport, including the original git commit
id to <stable@xxxxxxxxxxxxxxx>.
thanks,
greg k-h
------------------ original commit in Linus's tree ------------------
>From e16eceea863b417fd328588b1be1a79de0bc937f Mon Sep 17 00:00:00 2001
From: Olga Kitaina <okitain@xxxxxxxxx>
Date: Tue, 28 Jun 2022 21:18:24 +0530
Subject: [PATCH] mtd: rawnand: arasan: Fix clock rate in NV-DDR
According to the Arasan NAND controller spec, the flash clock rate for SDR
must be <= 100 MHz, while for NV-DDR it must be the same as the rate of the
CLK line for the mode. The driver previously always set 100 MHz for NV-DDR,
which would result in incorrect behavior for NV-DDR modes 0-4.
The appropriate clock rate can be calculated from the NV-DDR timing
parameters as 1/tCK, or for rates measured in picoseconds,
10^12 / nand_nvddr_timings->tCK_min.
Fixes: 197b88fecc50 ("mtd: rawnand: arasan: Add new Arasan NAND controller")
CC: stable@xxxxxxxxxxxxxxx # 5.8+
Signed-off-by: Olga Kitaina <okitain@xxxxxxxxx>
Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra@xxxxxxxxxx>
Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Link: https://lore.kernel.org/linux-mtd/20220628154824.12222-3-amit.kumar-mahapatra@xxxxxxxxxx
diff --git a/drivers/mtd/nand/raw/arasan-nand-controller.c b/drivers/mtd/nand/raw/arasan-nand-controller.c
index c5264fa223c4..296fb16c8dc3 100644
--- a/drivers/mtd/nand/raw/arasan-nand-controller.c
+++ b/drivers/mtd/nand/raw/arasan-nand-controller.c
@@ -1043,7 +1043,13 @@ static int anfc_setup_interface(struct nand_chip *chip, int target,
DQS_BUFF_SEL_OUT(dqs_mode);
}
- anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK;
+ if (nand_interface_is_sdr(conf)) {
+ anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK;
+ } else {
+ /* ONFI timings are defined in picoseconds */
+ anand->clk = div_u64((u64)NSEC_PER_SEC * 1000,
+ conf->timings.nvddr.tCK_min);
+ }
/*
* Due to a hardware bug in the ZynqMP SoC, SDR timing modes 0-1 work
