In current implementation the Arasan NAND driver is updating the
system clock(i.e., anand->clk) in accordance to the timing modes
(i.e., SDR or NVDDR). But as per the Arasan NAND controller spec the
flash clock or the NAND bus clock(i.e., nfc->bus_clk), need to be
updated instead. This patch keeps the system clock unchanged and updates
the NAND bus clock as per the timing modes.
Fixes: 197b88fecc50 ("mtd: rawnand: arasan: Add new Arasan NAND controller")
CC: stable@xxxxxxxxxxxxxxx # 5.8+
Signed-off-by: Amit Kumar Mahapatra <amit.kumar-mahapatra@xxxxxxxxxx>
---
drivers/mtd/nand/raw/arasan-nand-controller.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/mtd/nand/raw/arasan-nand-controller.c b/drivers/mtd/nand/raw/arasan-nand-controller.c
index 53bd10738418..c5264fa223c4 100644
--- a/drivers/mtd/nand/raw/arasan-nand-controller.c
+++ b/drivers/mtd/nand/raw/arasan-nand-controller.c
@@ -347,17 +347,17 @@ static int anfc_select_target(struct nand_chip *chip, int target)
/* Update clock frequency */
if (nfc->cur_clk != anand->clk) {
- clk_disable_unprepare(nfc->controller_clk);
- ret = clk_set_rate(nfc->controller_clk, anand->clk);
+ clk_disable_unprepare(nfc->bus_clk);
+ ret = clk_set_rate(nfc->bus_clk, anand->clk);
if (ret) {
dev_err(nfc->dev, "Failed to change clock rate\n");
return ret;
}
- ret = clk_prepare_enable(nfc->controller_clk);
+ ret = clk_prepare_enable(nfc->bus_clk);
if (ret) {
dev_err(nfc->dev,
- "Failed to re-enable the controller clock\n");
+ "Failed to re-enable the bus clock\n");
return ret;
}
--
2.17.1
