From: Russell King (Oracle) <rmk+kernel@xxxxxxxxxxxxxxx> [ Upstream commit 66f862563ed68717dfd84e808ca12705ed275ced ] When using an external PHY connected using RGMII to mt7531 port 5, the PHY can be used to used support 1000BASE-X connections. Moreover, if 1000BASE-T is supported, then we should allow 1000BASE-X as well, since which are supported is a property of the PHY. Therefore, it makes no sense to exclude this from the linkmodes when 1000BASE-T is supported. Fixes: c288575f7810 ("net: dsa: mt7530: Add the support of MT7531 switch") Tested-by: Marek Behún <kabel@xxxxxxxxxx> Signed-off-by: Russell King (Oracle) <rmk+kernel@xxxxxxxxxxxxxxx> Signed-off-by: Paolo Abeni <pabeni@xxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/net/dsa/mt7530.c | 14 ++++---------- 1 file changed, 4 insertions(+), 10 deletions(-) diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c index ca9e171cb2bb..be5c9cca8084 100644 --- a/drivers/net/dsa/mt7530.c +++ b/drivers/net/dsa/mt7530.c @@ -2527,13 +2527,7 @@ static void mt7531_sgmii_validate(struct mt7530_priv *priv, int port, /* Port5 supports ethier RGMII or SGMII. * Port6 supports SGMII only. */ - switch (port) { - case 5: - if (mt7531_is_rgmii_port(priv, port)) - break; - fallthrough; - case 6: - phylink_set(supported, 1000baseX_Full); + if (port == 6) { phylink_set(supported, 2500baseX_Full); phylink_set(supported, 2500baseT_Full); } @@ -2901,8 +2895,6 @@ static void mt7530_mac_port_validate(struct dsa_switch *ds, int port, unsigned long *supported) { - if (port == 5) - phylink_set(supported, 1000baseX_Full); } static void mt7531_mac_port_validate(struct dsa_switch *ds, int port, @@ -2939,8 +2931,10 @@ mt753x_phylink_validate(struct dsa_switch *ds, int port, } /* This switch only supports 1G full-duplex. */ - if (state->interface != PHY_INTERFACE_MODE_MII) + if (state->interface != PHY_INTERFACE_MODE_MII) { phylink_set(mask, 1000baseT_Full); + phylink_set(mask, 1000baseX_Full); + } priv->info->mac_port_validate(ds, port, mask); -- 2.35.1