From: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxx>
commit e1bfdbc7daca171c74a577b3dd0b36d76bb0ffcc upstream.
The XON1/XOFF1 character registers are at offset 0xa0 and 0xa8
respectively, so we cannot use the definition in serial_port.h.
Fixes: bdbd0a7f8f03 ("serial: 8250-mtk: modify baudrate setting")
Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxx>
Cc: stable <stable@xxxxxxxxxxxxxxx>
Link: https://lore.kernel.org/r/20220427132328.228297-4-angelogioacchino.delregno@xxxxxxxxxxxxx
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/tty/serial/8250/8250_mtk.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
--- a/drivers/tty/serial/8250/8250_mtk.c
+++ b/drivers/tty/serial/8250/8250_mtk.c
@@ -54,6 +54,9 @@
#define MTK_UART_TX_TRIGGER 1
#define MTK_UART_RX_TRIGGER MTK_UART_RX_SIZE
+#define MTK_UART_XON1 40 /* I/O: Xon character 1 */
+#define MTK_UART_XOFF1 42 /* I/O: Xoff character 1 */
+
#ifdef CONFIG_SERIAL_8250_DMA
enum dma_rx_status {
DMA_RX_START = 0,
@@ -275,8 +278,8 @@ static void mtk8250_set_flow_ctrl(struct
(serial_in(up, MTK_UART_EFR) &
(~(MTK_UART_EFR_HW_FC | MTK_UART_EFR_SW_FC_MASK))));
- serial_out(up, UART_XON1, START_CHAR(port->state->port.tty));
- serial_out(up, UART_XOFF1, STOP_CHAR(port->state->port.tty));
+ serial_out(up, MTK_UART_XON1, START_CHAR(port->state->port.tty));
+ serial_out(up, MTK_UART_XOFF1, STOP_CHAR(port->state->port.tty));
serial_out(up, UART_LCR, lcr);
mtk8250_disable_intrs(up, MTK_UART_IER_CTSI|MTK_UART_IER_RTSI);
mtk8250_enable_intrs(up, MTK_UART_IER_XOFFI);
