update documentation to correctly state the interrupt-cells to be 2.
Cc: stable@xxxxxxxxxxxxxxx
Fixes: 4fd9bbc6e071 ("drivers/gpio: Altera soft IP GPIO driver devicetree binding")
Signed-off-by: Dinh Nguyen <dinguyen@xxxxxxxxxx>
---
Documentation/devicetree/bindings/gpio/gpio-altera.txt | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/gpio/gpio-altera.txt b/Documentation/devicetree/bindings/gpio/gpio-altera.txt
index 146e554b3c67..2a80e272cd66 100644
--- a/Documentation/devicetree/bindings/gpio/gpio-altera.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio-altera.txt
@@ -9,8 +9,9 @@ Required properties:
- The second cell is reserved and is currently unused.
- gpio-controller : Marks the device node as a GPIO controller.
- interrupt-controller: Mark the device node as an interrupt controller
-- #interrupt-cells : Should be 1. The interrupt type is fixed in the hardware.
+- #interrupt-cells : Should be 2. The interrupt type is fixed in the hardware.
- The first cell is the GPIO offset number within the GPIO controller.
+ - The second cell is the interrupt trigger type and level flags.
- interrupts: Specify the interrupt.
- altr,interrupt-type: Specifies the interrupt trigger type the GPIO
hardware is synthesized. This field is required if the Altera GPIO controller
@@ -38,6 +39,6 @@ gpio_altr: gpio@ff200000 {
altr,interrupt-type = <IRQ_TYPE_EDGE_RISING>;
#gpio-cells = <2>;
gpio-controller;
- #interrupt-cells = <1>;
+ #interrupt-cells = <2>;
interrupt-controller;
};
--
2.25.1
