From: Shravya Kumbham <shravya.kumbham@xxxxxxxxxx> commit 7a6bc33ab54923d325d9a1747ec9652c4361ebd1 upstream. check the return value of of_address_to_resource() and also add missing of_node_put() for np and npp nodes. Fixes: e0a3bc65448c ("net: emaclite: Support multiple phys connected to one MDIO bus") Addresses-Coverity: Event check_return value. Signed-off-by: Shravya Kumbham <shravya.kumbham@xxxxxxxxxx> Signed-off-by: Radhey Shyam Pandey <radhey.shyam.pandey@xxxxxxxxxx> Signed-off-by: Paolo Abeni <pabeni@xxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/net/ethernet/xilinx/xilinx_emaclite.c | 15 ++++++++++++--- 1 file changed, 12 insertions(+), 3 deletions(-) --- a/drivers/net/ethernet/xilinx/xilinx_emaclite.c +++ b/drivers/net/ethernet/xilinx/xilinx_emaclite.c @@ -817,10 +817,10 @@ static int xemaclite_mdio_write(struct m static int xemaclite_mdio_setup(struct net_local *lp, struct device *dev) { struct mii_bus *bus; - int rc; struct resource res; struct device_node *np = of_get_parent(lp->phy_node); struct device_node *npp; + int rc, ret; /* Don't register the MDIO bus if the phy_node or its parent node * can't be found. @@ -830,8 +830,14 @@ static int xemaclite_mdio_setup(struct n return -ENODEV; } npp = of_get_parent(np); - - of_address_to_resource(npp, 0, &res); + ret = of_address_to_resource(npp, 0, &res); + of_node_put(npp); + if (ret) { + dev_err(dev, "%s resource error!\n", + dev->of_node->full_name); + of_node_put(np); + return ret; + } if (lp->ndev->mem_start != res.start) { struct phy_device *phydev; phydev = of_phy_find_device(lp->phy_node); @@ -840,6 +846,7 @@ static int xemaclite_mdio_setup(struct n "MDIO of the phy is not registered yet\n"); else put_device(&phydev->mdio.dev); + of_node_put(np); return 0; } @@ -852,6 +859,7 @@ static int xemaclite_mdio_setup(struct n bus = mdiobus_alloc(); if (!bus) { dev_err(dev, "Failed to allocate mdiobus\n"); + of_node_put(np); return -ENOMEM; } @@ -866,6 +874,7 @@ static int xemaclite_mdio_setup(struct n lp->mii_bus = bus; rc = of_mdiobus_register(bus, np); + of_node_put(np); if (rc) { dev_err(dev, "Failed to register mdio bus.\n"); goto err_register;