From: Chen-Yu Tsai <wens@xxxxxxxx>
[ Upstream commit c21cabb0fd0b54b8b54235fc1ecfe1195a23bcb2 ]
In commit 9cbadf094d9d ("net: stmmac: support max-speed device tree
property"), when DT platforms don't set "max-speed", max_speed is set to
-1; for non-DT platforms, it stays the default 0.
Prior to commit eeef2f6b9f6e ("net: stmmac: Start adding phylink support"),
the check for a valid max_speed setting was to check if it was greater
than zero. This commit got it right, but subsequent patches just checked
for non-zero, which is incorrect for DT platforms.
In commit 92c3807b9ac3 ("net: stmmac: convert to phylink_get_linkmodes()")
the conversion switched completely to checking for non-zero value as a
valid value, which caused 1000base-T to stop getting advertised by
default.
Instead of trying to fix all the checks, simply leave max_speed alone if
DT property parsing fails.
Fixes: 9cbadf094d9d ("net: stmmac: support max-speed device tree property")
Fixes: 92c3807b9ac3 ("net: stmmac: convert to phylink_get_linkmodes()")
Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>
Acked-by: Russell King (Oracle) <rmk+kernel@xxxxxxxxxxxxxxx>
Reviewed-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
Link: https://lore.kernel.org/r/20220331184832.16316-1-wens@xxxxxxxxxx
Signed-off-by: Jakub Kicinski <kuba@xxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c | 3 +--
1 file changed, 1 insertion(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
index d008e9d1518b..14d11f9fcbe8 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
@@ -388,8 +388,7 @@ stmmac_probe_config_dt(struct platform_device *pdev, const char **mac)
plat->interface = of_get_phy_mode(np);
/* Get max speed of operation from device tree */
- if (of_property_read_u32(np, "max-speed", &plat->max_speed))
- plat->max_speed = -1;
+ of_property_read_u32(np, "max-speed", &plat->max_speed);
plat->bus_id = of_alias_get_id(np, "ethernet");
if (plat->bus_id < 0)
--
2.35.1
