From: Andy Chiu <andy.chiu@xxxxxxxxxx> [ Upstream commit d1c4f93e3f0a023024a6f022a61528c06cf1daa9 ] The call to axienet_mdio_setup should not depend on whether "phy-node" pressents on the DT. Besides, since `lp->phy_node` is used if PHY is in SGMII or 100Base-X modes, move it into the if statement. And the next patch will remove `lp->phy_node` from driver's private structure and do an of_node_put on it right away after use since it is not used elsewhere. Signed-off-by: Andy Chiu <andy.chiu@xxxxxxxxxx> Reviewed-by: Greentime Hu <greentime.hu@xxxxxxxxxx> Reviewed-by: Robert Hancock <robert.hancock@xxxxxxxxxx> Reviewed-by: Radhey Shyam Pandey <radhey.shyam.pandey@xxxxxxxxxx> Reviewed-by: Andrew Lunn <andrew@xxxxxxx> Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/net/ethernet/xilinx/xilinx_axienet_main.c | 13 ++++++------- 1 file changed, 6 insertions(+), 7 deletions(-) diff --git a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c index bbdcba88c021..3d91baf2e55a 100644 --- a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c +++ b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c @@ -2060,15 +2060,14 @@ static int axienet_probe(struct platform_device *pdev) if (ret) goto cleanup_clk; - lp->phy_node = of_parse_phandle(pdev->dev.of_node, "phy-handle", 0); - if (lp->phy_node) { - ret = axienet_mdio_setup(lp); - if (ret) - dev_warn(&pdev->dev, - "error registering MDIO bus: %d\n", ret); - } + ret = axienet_mdio_setup(lp); + if (ret) + dev_warn(&pdev->dev, + "error registering MDIO bus: %d\n", ret); + if (lp->phy_mode == PHY_INTERFACE_MODE_SGMII || lp->phy_mode == PHY_INTERFACE_MODE_1000BASEX) { + lp->phy_node = of_parse_phandle(pdev->dev.of_node, "phy-handle", 0); if (!lp->phy_node) { dev_err(&pdev->dev, "phy-handle required for 1000BaseX/SGMII\n"); ret = -EINVAL; -- 2.35.1