From: Sean Young <sean@xxxxxxxx> commit fdc881783099c6343921ff017450831c8766d12a upstream. On an Intel NUC6iSYK, no IR is reported after a receive overflow. When a receiver overflow occurs, this condition is only cleared by reading the fifo. Make sure we read anything in the fifo. Fixes: 28c7afb07ccf ("media: ite-cir: check for receive overflow") Suggested-by: Bryan Pass <bryan.pass@xxxxxxxxx> Tested-by: Bryan Pass <bryan.pass@xxxxxxxxx> Cc: stable@xxxxxxxxxxxxxxx> Signed-off-by: Sean Young <sean@xxxxxxxx> Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@xxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/media/rc/ite-cir.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) --- a/drivers/media/rc/ite-cir.c +++ b/drivers/media/rc/ite-cir.c @@ -242,7 +242,7 @@ static irqreturn_t ite_cir_isr(int irq, } /* check for the receive interrupt */ - if (iflags & ITE_IRQ_RX_FIFO) { + if (iflags & (ITE_IRQ_RX_FIFO | ITE_IRQ_RX_FIFO_OVERRUN)) { /* read the FIFO bytes */ rx_bytes = dev->params->get_rx_bytes(dev, rx_buf, ITE_RX_FIFO_LEN);