From: Erik Ekman <erik@xxxxxxx>
commit 041c61488236a5a84789083e3d9f0a51139b6edf upstream.
Everything except the first 32 bits was lost when the pause flags were
added. This makes the 50000baseCR2 mode flag (bit 34) not appear.
I have tested this with a 10G card (SFN5122F-R7) by modifying it to
return a non-legacy link mode (10000baseCR).
Signed-off-by: Erik Ekman <erik@xxxxxxx>
Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/net/ethernet/sfc/ethtool.c | 10 ++--------
1 file changed, 2 insertions(+), 8 deletions(-)
--- a/drivers/net/ethernet/sfc/ethtool.c
+++ b/drivers/net/ethernet/sfc/ethtool.c
@@ -131,20 +131,14 @@ efx_ethtool_get_link_ksettings(struct ne
{
struct efx_nic *efx = netdev_priv(net_dev);
struct efx_link_state *link_state = &efx->link_state;
- u32 supported;
mutex_lock(&efx->mac_lock);
efx->phy_op->get_link_ksettings(efx, cmd);
mutex_unlock(&efx->mac_lock);
/* Both MACs support pause frames (bidirectional and respond-only) */
- ethtool_convert_link_mode_to_legacy_u32(&supported,
- cmd->link_modes.supported);
-
- supported |= SUPPORTED_Pause | SUPPORTED_Asym_Pause;
-
- ethtool_convert_legacy_u32_to_link_mode(cmd->link_modes.supported,
- supported);
+ ethtool_link_ksettings_add_link_mode(cmd, supported, Pause);
+ ethtool_link_ksettings_add_link_mode(cmd, supported, Asym_Pause);
if (LOOPBACK_INTERNAL(efx)) {
cmd->base.speed = link_state->speed;
