From: Dmitry Osipenko <digetx@xxxxxxxxx>
[ Upstream commit efe2175478d5237949e33c84d9a722fc084b218c ]
Pin control needs to be activated by setting the enable bit, otherwise
hardware rejects all pin changes. Previously this stayed unnoticed on
Nexus 7 because pin control was enabled by default after rebooting from
downstream kernel, which uses driver that enables the bit and charger
registers are non-volatile until power supply (battery) is disconnected.
Configure the pin control enable bit. This fixes the potentially
never-enabled charging on devices that use pin control.
Signed-off-by: Dmitry Osipenko <digetx@xxxxxxxxx>
Signed-off-by: Sebastian Reichel <sebastian.reichel@xxxxxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
drivers/power/supply/smb347-charger.c | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/drivers/power/supply/smb347-charger.c b/drivers/power/supply/smb347-charger.c
index 3376f42d46c3..25d239f2330e 100644
--- a/drivers/power/supply/smb347-charger.c
+++ b/drivers/power/supply/smb347-charger.c
@@ -56,6 +56,7 @@
#define CFG_PIN_EN_CTRL_ACTIVE_LOW 0x60
#define CFG_PIN_EN_APSD_IRQ BIT(1)
#define CFG_PIN_EN_CHARGER_ERROR BIT(2)
+#define CFG_PIN_EN_CTRL BIT(4)
#define CFG_THERM 0x07
#define CFG_THERM_SOFT_HOT_COMPENSATION_MASK 0x03
#define CFG_THERM_SOFT_HOT_COMPENSATION_SHIFT 0
@@ -725,6 +726,15 @@ static int smb347_hw_init(struct smb347_charger *smb)
if (ret < 0)
goto fail;
+ /* Activate pin control, making it writable. */
+ switch (smb->enable_control) {
+ case SMB3XX_CHG_ENABLE_PIN_ACTIVE_LOW:
+ case SMB3XX_CHG_ENABLE_PIN_ACTIVE_HIGH:
+ ret = regmap_set_bits(smb->regmap, CFG_PIN, CFG_PIN_EN_CTRL);
+ if (ret < 0)
+ goto fail;
+ }
+
/*
* Make the charging functionality controllable by a write to the
* command register unless pin control is specified in the platform
--
2.30.2
