From: Vincent Whitchurch <vincent.whitchurch@xxxxxxxx> [ Upstream commit 25f8203b4be1937c4939bb98623e67dcfd7da4d1 ] When a Data CRC interrupt is received, the driver disables the DMA, then sends the stop/abort command and then waits for Data Transfer Over. However, sometimes, when a data CRC error is received in the middle of a multi-block write transfer, the Data Transfer Over interrupt is never received, and the driver hangs and never completes the request. The driver sets the BMOD.SWR bit (SDMMC_IDMAC_SWRESET) when stopping the DMA, but according to the manual CMD.STOP_ABORT_CMD should be programmed "before assertion of SWR". Do these operations in the recommended order. With this change the Data Transfer Over is always received correctly in my tests. Signed-off-by: Vincent Whitchurch <vincent.whitchurch@xxxxxxxx> Reviewed-by: Jaehoon Chung <jh80.chung@xxxxxxxxxxx> Cc: stable@xxxxxxxxxxxxxxx Link: https://lore.kernel.org/r/20210630102232.16011-1-vincent.whitchurch@xxxxxxxx Signed-off-by: Ulf Hansson <ulf.hansson@xxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/mmc/host/dw_mmc.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c index 32001d43e453..bd994a8fce14 100644 --- a/drivers/mmc/host/dw_mmc.c +++ b/drivers/mmc/host/dw_mmc.c @@ -2051,8 +2051,8 @@ static void dw_mci_tasklet_func(unsigned long priv) continue; } - dw_mci_stop_dma(host); send_stop_abort(host, data); + dw_mci_stop_dma(host); state = STATE_SENDING_STOP; break; } @@ -2076,10 +2076,10 @@ static void dw_mci_tasklet_func(unsigned long priv) */ if (test_and_clear_bit(EVENT_DATA_ERROR, &host->pending_events)) { - dw_mci_stop_dma(host); if (!(host->data_status & (SDMMC_INT_DRTO | SDMMC_INT_EBE))) send_stop_abort(host, data); + dw_mci_stop_dma(host); state = STATE_DATA_ERROR; break; } @@ -2112,10 +2112,10 @@ static void dw_mci_tasklet_func(unsigned long priv) */ if (test_and_clear_bit(EVENT_DATA_ERROR, &host->pending_events)) { - dw_mci_stop_dma(host); if (!(host->data_status & (SDMMC_INT_DRTO | SDMMC_INT_EBE))) send_stop_abort(host, data); + dw_mci_stop_dma(host); state = STATE_DATA_ERROR; break; } -- 2.30.2
