From: Wesley Cheng <wcheng@xxxxxxxxxxxxxx> [ Upstream commit 77adb8bdf4227257e26b7ff67272678e66a0b250 ] The DWC3 runtime suspend routine checks for the USB connected parameter to determine if the controller can enter into a low power state. The connected state is only set to false after receiving a disconnect event. However, in the case of a device initiated disconnect (i.e. UDC unbind), the controller is halted and a disconnect event is never generated. Set the connected flag to false if issuing a device initiated disconnect to allow the controller to be suspended. Signed-off-by: Wesley Cheng <wcheng@xxxxxxxxxxxxxx> Link: https://lore.kernel.org/r/1609283136-22140-2-git-send-email-wcheng@xxxxxxxxxxxxxx Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/usb/dwc3/gadget.c | 13 +++++++++++++ 1 file changed, 13 insertions(+) --- a/drivers/usb/dwc3/gadget.c +++ b/drivers/usb/dwc3/gadget.c @@ -2018,6 +2018,17 @@ static int dwc3_gadget_pullup(struct usb } /* + * Check the return value for successful resume, or error. For a + * successful resume, the DWC3 runtime PM resume routine will handle + * the run stop sequence, so avoid duplicate operations here. + */ + ret = pm_runtime_get_sync(dwc->dev); + if (!ret || ret < 0) { + pm_runtime_put(dwc->dev); + return 0; + } + + /* * Synchronize any pending event handling before executing the controller * halt routine. */ @@ -2055,10 +2066,12 @@ static int dwc3_gadget_pullup(struct usb dwc->ev_buf->lpos = (dwc->ev_buf->lpos + count) % dwc->ev_buf->length; } + dwc->connected = false; } ret = dwc3_gadget_run_stop(dwc, is_on, false); spin_unlock_irqrestore(&dwc->lock, flags); + pm_runtime_put(dwc->dev); return ret; }
