From: Longfang Liu <liulongfang@xxxxxxxxxx> commit 26b75952ca0b8b4b3050adb9582c8e2f44d49687 upstream. Kunpeng920's EHCI controller does not have SBRN register. Reading the SBRN register when the controller driver is initialized will get 0. When rebooting the EHCI driver, ehci_shutdown() will be called. if the sbrn flag is 0, ehci_shutdown() will return directly. The sbrn flag being 0 will cause the EHCI interrupt signal to not be turned off after reboot. this interrupt that is not closed will cause an exception to the device sharing the interrupt. Therefore, the EHCI controller of Kunpeng920 needs to skip the read operation of the SBRN register. Acked-by: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx> Signed-off-by: Longfang Liu <liulongfang@xxxxxxxxxx> Link: https://lore.kernel.org/r/1617958081-17999-1-git-send-email-liulongfang@xxxxxxxxxx Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/usb/host/ehci-pci.c | 3 +++ 1 file changed, 3 insertions(+) --- a/drivers/usb/host/ehci-pci.c +++ b/drivers/usb/host/ehci-pci.c @@ -311,6 +311,9 @@ static int ehci_pci_setup(struct usb_hcd if (pdev->vendor == PCI_VENDOR_ID_STMICRO && pdev->device == PCI_DEVICE_ID_STMICRO_USB_HOST) ; /* ConneXT has no sbrn register */ + else if (pdev->vendor == PCI_VENDOR_ID_HUAWEI + && pdev->device == 0xa239) + ; /* HUAWEI Kunpeng920 USB EHCI has no sbrn register */ else pci_read_config_byte(pdev, 0x60, &ehci->sbrn);
