From: Krzysztof Kozlowski <krzk@xxxxxxxxxx> [ Upstream commit 742b0d7e15c333303daad4856de0764f4bc83601 ] Interrupt line can be configured on different hardware in different way, even inverted. Therefore driver should not enforce specific trigger type - edge falling - but instead rely on Devicetree to configure it. The Maxim 77686 datasheet describes the interrupt line as active low with a requirement of acknowledge from the CPU therefore the edge falling is not correct. The interrupt line is shared between PMIC and RTC driver, so using level sensitive interrupt is here especially important to avoid races. With an edge configuration in case if first PMIC signals interrupt followed shortly after by the RTC, the interrupt might not be yet cleared/acked thus the second one would not be noticed. Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx> Signed-off-by: Alexandre Belloni <alexandre.belloni@xxxxxxxxxxx> Link: https://lore.kernel.org/r/20210526172036.183223-6-krzysztof.kozlowski@xxxxxxxxxxxxx Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/rtc/rtc-max77686.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/rtc/rtc-max77686.c b/drivers/rtc/rtc-max77686.c index d51cc12114cb..eae7cb9faf1e 100644 --- a/drivers/rtc/rtc-max77686.c +++ b/drivers/rtc/rtc-max77686.c @@ -717,8 +717,8 @@ static int max77686_init_rtc_regmap(struct max77686_rtc_info *info) add_rtc_irq: ret = regmap_add_irq_chip(info->rtc_regmap, info->rtc_irq, - IRQF_TRIGGER_FALLING | IRQF_ONESHOT | - IRQF_SHARED, 0, info->drv_data->rtc_irq_chip, + IRQF_ONESHOT | IRQF_SHARED, + 0, info->drv_data->rtc_irq_chip, &info->rtc_irq_data); if (ret < 0) { dev_err(info->dev, "Failed to add RTC irq chip: %d\n", ret); -- 2.30.2
