From: Kuogee Hsieh <khsieh@xxxxxxxxxxxxxx>
commit d9aa6571b28ba0022de1e48801ff03a1854c7ef2 upstream.
Link status is different from display connected status in the case
of something like an Apple dongle where the type-c plug can be
connected, and therefore the link is connected, but no sink is
connected until an HDMI cable is plugged into the dongle.
The sink_count of DPCD of dongle will increase to 1 once an HDMI
cable is plugged into the dongle so that display connected status
will become true. This checking also apply at pm_resume.
Changes in v4:
-- none
Fixes: 94e58e2d06e3 ("drm/msm/dp: reset dp controller only at boot up and pm_resume")
Reported-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
Reviewed-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
Tested-by: Stephen Boyd <swboyd@xxxxxxxxxxxx>
Signed-off-by: Kuogee Hsieh <khsieh@xxxxxxxxxxxxxx>
Fixes: 8ede2ecc3e5e ("drm/msm/dp: Add DP compliance tests on Snapdragon Chipsets")
Link: https://lore.kernel.org/r/1619048258-8717-2-git-send-email-khsieh@xxxxxxxxxxxxxx
Signed-off-by: Rob Clark <robdclark@xxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/gpu/drm/msm/dp/dp_display.c | 15 ++++++++-------
1 file changed, 8 insertions(+), 7 deletions(-)
--- a/drivers/gpu/drm/msm/dp/dp_display.c
+++ b/drivers/gpu/drm/msm/dp/dp_display.c
@@ -595,10 +595,8 @@ static int dp_connect_pending_timeout(st
mutex_lock(&dp->event_mutex);
state = dp->hpd_state;
- if (state == ST_CONNECT_PENDING) {
- dp_display_enable(dp, 0);
+ if (state == ST_CONNECT_PENDING)
dp->hpd_state = ST_CONNECTED;
- }
mutex_unlock(&dp->event_mutex);
@@ -677,10 +675,8 @@ static int dp_disconnect_pending_timeout
mutex_lock(&dp->event_mutex);
state = dp->hpd_state;
- if (state == ST_DISCONNECT_PENDING) {
- dp_display_disable(dp, 0);
+ if (state == ST_DISCONNECT_PENDING)
dp->hpd_state = ST_DISCONNECTED;
- }
mutex_unlock(&dp->event_mutex);
@@ -1272,7 +1268,12 @@ static int dp_pm_resume(struct device *d
status = dp_catalog_link_is_connected(dp->catalog);
- if (status)
+ /*
+ * can not declared display is connected unless
+ * HDMI cable is plugged in and sink_count of
+ * dongle become 1
+ */
+ if (status && dp->link->sink_count)
dp->dp_display.is_connected = true;
else
dp->dp_display.is_connected = false;
