From: Dinghao Liu <dinghao.liu@xxxxxxxxxx> [ Upstream commit a21fbc42807b15b74b0891bd557063e6acf4fcae ] When platform_get_irq() fails, a pairing PM usage counter increment is needed to keep the counter balanced. It's the same for the following error paths. Signed-off-by: Dinghao Liu <dinghao.liu@xxxxxxxxxx> Link: https://lore.kernel.org/r/20210408092559.3824-1-dinghao.liu@xxxxxxxxxx Signed-off-by: Mark Brown <broonie@xxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/spi/spi-zynqmp-gqspi.c | 14 ++++++++++++-- 1 file changed, 12 insertions(+), 2 deletions(-) diff --git a/drivers/spi/spi-zynqmp-gqspi.c b/drivers/spi/spi-zynqmp-gqspi.c index 408e348382c5..32e53f379e9b 100644 --- a/drivers/spi/spi-zynqmp-gqspi.c +++ b/drivers/spi/spi-zynqmp-gqspi.c @@ -1163,11 +1163,16 @@ static int zynqmp_qspi_probe(struct platform_device *pdev) pm_runtime_set_autosuspend_delay(&pdev->dev, SPI_AUTOSUSPEND_TIMEOUT); pm_runtime_set_active(&pdev->dev); pm_runtime_enable(&pdev->dev); + + ret = pm_runtime_get_sync(&pdev->dev); + if (ret < 0) { + dev_err(&pdev->dev, "Failed to pm_runtime_get_sync: %d\n", ret); + goto clk_dis_all; + } + /* QSPI controller initializations */ zynqmp_qspi_init_hw(xqspi); - pm_runtime_mark_last_busy(&pdev->dev); - pm_runtime_put_autosuspend(&pdev->dev); xqspi->irq = platform_get_irq(pdev, 0); if (xqspi->irq <= 0) { ret = -ENXIO; @@ -1190,6 +1195,7 @@ static int zynqmp_qspi_probe(struct platform_device *pdev) ctlr->mode_bits = SPI_CPOL | SPI_CPHA | SPI_RX_DUAL | SPI_RX_QUAD | SPI_TX_DUAL | SPI_TX_QUAD; ctlr->dev.of_node = np; + ctlr->auto_runtime_pm = true; ret = devm_spi_register_controller(&pdev->dev, ctlr); if (ret) { @@ -1197,9 +1203,13 @@ static int zynqmp_qspi_probe(struct platform_device *pdev) goto clk_dis_all; } + pm_runtime_mark_last_busy(&pdev->dev); + pm_runtime_put_autosuspend(&pdev->dev); + return 0; clk_dis_all: + pm_runtime_put_sync(&pdev->dev); pm_runtime_set_suspended(&pdev->dev); pm_runtime_disable(&pdev->dev); clk_disable_unprepare(xqspi->refclk); -- 2.30.2
