From: Adrian Hunter <adrian.hunter@xxxxxxxxx> commit 2970134b927834e9249659a70aac48e62dff804a upstream. Bus power may control card power, but the full reset done by SDHCI at initialization still may not reset the power, whereas a direct write to SDHCI_POWER_CONTROL can. That might be needed to initialize correctly, if the card was left powered on previously. Signed-off-by: Adrian Hunter <adrian.hunter@xxxxxxxxx> Cc: stable@xxxxxxxxxxxxxxx Link: https://lore.kernel.org/r/20210331081752.23621-1-adrian.hunter@xxxxxxxxx Signed-off-by: Ulf Hansson <ulf.hansson@xxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/mmc/host/sdhci-pci-core.c | 27 +++++++++++++++++++++++++++ 1 file changed, 27 insertions(+) --- a/drivers/mmc/host/sdhci-pci-core.c +++ b/drivers/mmc/host/sdhci-pci-core.c @@ -516,6 +516,7 @@ struct intel_host { int drv_strength; bool d3_retune; bool rpm_retune_ok; + bool needs_pwr_off; u32 glk_rx_ctrl1; u32 glk_tun_val; u32 active_ltr; @@ -643,9 +644,25 @@ out: static void sdhci_intel_set_power(struct sdhci_host *host, unsigned char mode, unsigned short vdd) { + struct sdhci_pci_slot *slot = sdhci_priv(host); + struct intel_host *intel_host = sdhci_pci_priv(slot); int cntr; u8 reg; + /* + * Bus power may control card power, but a full reset still may not + * reset the power, whereas a direct write to SDHCI_POWER_CONTROL can. + * That might be needed to initialize correctly, if the card was left + * powered on previously. + */ + if (intel_host->needs_pwr_off) { + intel_host->needs_pwr_off = false; + if (mode != MMC_POWER_OFF) { + sdhci_writeb(host, 0, SDHCI_POWER_CONTROL); + usleep_range(10000, 12500); + } + } + sdhci_set_power(host, mode, vdd); if (mode == MMC_POWER_OFF) @@ -1135,6 +1152,14 @@ static int byt_sdio_probe_slot(struct sd return 0; } +static void byt_needs_pwr_off(struct sdhci_pci_slot *slot) +{ + struct intel_host *intel_host = sdhci_pci_priv(slot); + u8 reg = sdhci_readb(slot->host, SDHCI_POWER_CONTROL); + + intel_host->needs_pwr_off = reg & SDHCI_POWER_ON; +} + static int byt_sd_probe_slot(struct sdhci_pci_slot *slot) { byt_probe_slot(slot); @@ -1152,6 +1177,8 @@ static int byt_sd_probe_slot(struct sdhc slot->chip->pdev->subsystem_device == PCI_SUBDEVICE_ID_NI_78E3) slot->host->mmc->caps2 |= MMC_CAP2_AVOID_3_3V; + byt_needs_pwr_off(slot); + return 0; }