From: Russell King <rmk+kernel@xxxxxxxxxxxxxxx> commit 7a77233ec6d114322e2c4f71b4e26dbecd9ea8a7 upstream. Do not check the encoding when deriving 1000BASE-X from the bitrate when no other modes are discovered. Some GPON modules (VSOL V2801F and CarlitoxxPro CPGOS03-0490 v2.0) indicate NRZ encoding with a 1200Mbaud bitrate, but should be driven with 1000BASE-X on the host side. Tested-by: Pali Rohár <pali@xxxxxxxxxx> Reviewed-by: Andrew Lunn <andrew@xxxxxxx> Signed-off-by: Russell King <rmk+kernel@xxxxxxxxxxxxxxx> Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/net/phy/sfp-bus.c | 11 +++++------ 1 file changed, 5 insertions(+), 6 deletions(-) --- a/drivers/net/phy/sfp-bus.c +++ b/drivers/net/phy/sfp-bus.c @@ -349,14 +349,13 @@ void sfp_parse_support(struct sfp_bus *b } /* If we haven't discovered any modes that this module supports, try - * the encoding and bitrate to determine supported modes. Some BiDi - * modules (eg, 1310nm/1550nm) are not 1000BASE-BX compliant due to - * the differing wavelengths, so do not set any transceiver bits. + * the bitrate to determine supported modes. Some BiDi modules (eg, + * 1310nm/1550nm) are not 1000BASE-BX compliant due to the differing + * wavelengths, so do not set any transceiver bits. */ if (bitmap_empty(modes, __ETHTOOL_LINK_MODE_MASK_NBITS)) { - /* If the encoding and bit rate allows 1000baseX */ - if (id->base.encoding == SFF8024_ENCODING_8B10B && br_nom && - br_min <= 1300 && br_max >= 1200) + /* If the bit rate allows 1000baseX */ + if (br_nom && br_min <= 1300 && br_max >= 1200) phylink_set(modes, 1000baseX_Full); }