From: Marek Vasut <marex@xxxxxxx>
[ Upstream commit 83d411224025ac1baab981e3d2f5d29e7761541d ]
The GPIO hog flags are ignored by gpiolib-of.c now, set the flags to 0.
Since GPIO_ACTIVE_HIGH is defined as 0, this change only increases the
correctness of the DT.
Fixes: fde180f06d7b ("ARM: dts: stm32: Add DHSOM based DRC02 board")
Signed-off-by: Marek Vasut <marex@xxxxxxx>
Cc: Alexandre Torgue <alexandre.torgue@xxxxxx>
Cc: Maxime Coquelin <mcoquelin.stm32@xxxxxxxxx>
Cc: Patrice Chotard <patrice.chotard@xxxxxx>
Cc: Patrick Delaunay <patrick.delaunay@xxxxxx>
Cc: linux-stm32@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
To: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
Signed-off-by: Alexandre Torgue <alexandre.torgue@xxxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
index 4cabdade6432b..e4d287d994214 100644
--- a/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
+++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-drc02.dtsi
@@ -35,7 +35,7 @@
*/
rs485-rx-en {
gpio-hog;
- gpios = <8 GPIO_ACTIVE_HIGH>;
+ gpios = <8 0>;
output-low;
line-name = "rs485-rx-en";
};
@@ -63,7 +63,7 @@
*/
usb-hub {
gpio-hog;
- gpios = <2 GPIO_ACTIVE_HIGH>;
+ gpios = <2 0>;
output-high;
line-name = "usb-hub-reset";
};
--
2.27.0
