Re: [PATCH] watchdog: qcom: Remove incorrect usage of QCOM_WDT_ENABLE_IRQ

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 2021-01-31 22:33, Jorge Ramirez-Ortiz, Foundries wrote:
On 28/01/21, Sai Prakash Ranjan wrote:
On 2021-01-28 13:49, Jorge Ramirez-Ortiz, Foundries wrote:
> On 26/01/21, Sai Prakash Ranjan wrote:
> > As per register documentation, QCOM_WDT_ENABLE_IRQ which is BIT(1)
> > of watchdog control register is wakeup interrupt enable bit and
> > not related to bark interrupt at all, BIT(0) is used for that.
> > So remove incorrect usage of this bit when supporting bark irq for
> > pre-timeout notification. Currently with this bit set and bark
> > interrupt specified, pre-timeout notification and/or watchdog
> > reset/bite does not occur.
> >
> > Fixes: 36375491a439 ("watchdog: qcom: support pre-timeout when the
> > bark irq is available")
> > Cc: stable@xxxxxxxxxxxxxxx
> > Signed-off-by: Sai Prakash Ranjan <saiprakash.ranjan@xxxxxxxxxxxxxx>
> > ---
> >
> > Reading the conversations from when qcom pre-timeout support was
> > added [1], Bjorn already had mentioned it was not right to touch this
> > bit, not sure which SoC the pre-timeout was tested on at that time,
> > but I have tested this on SDM845, SM8150, SC7180 and watchdog bark
> > and bite does not occur with enabling this bit with the bark irq
> > specified in DT.
>
> this was tested on QCS404. have you validated there? unfortunately I
> no longer have access to that hardware or the documentation
>

I didn't validate on qcs404 yet since I didn't have access to it.
But now that you mention it, let me arrange for a setup and test it
there as well. Note: I did not see bark irq entry in upstream qcs404
dtsi, so you must have had some local change when you tested?

TBH I dont quite remember. I suppose that if those with access to the
documents and hardware are OK with this change then it shouldnt cause
regressions (I just cant check from my end)


No worries, I got the documentation access now and it is the same as
other SoCs which I have tested above, meaning the BIT(1) is not related
to bark irq. I am arranging a setup as well now, it took some time as
I don't work on QCS* chipsets but I can confirm by this week.

Thanks,
Sai

--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation



[Index of Archives]     [Linux Kernel]     [Kernel Development Newbies]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Hiking]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux