On 08/01/2021 12:23, Felipe Balbi wrote:
Hi,
Thinh Nguyen <Thinh.Nguyen@xxxxxxxxxxxx> writes:
How have you verified this patch? Did you read Bryan's commit log? This
is likely to reintroduce the problem raised by Bryan.
We verified with our FPGA HAPS with various number of endpoints. No
issue is seen.
That's cool. Could you please make sure our understanding of this is
sound and won't interfere with any designs? If we modify this part of
the code again, I'd like to see a clear reference to a specific section
of the databook detailing the expected behavior :-)
cheers
Hm... I didn't consider bidirection endpoint other than control endpoint.
DWC3_USB3x_NUM_EPS specifies the number of device mode for single
directional endpoints. A bidirectional endpoint needs 2 single
directional endpoints, 1 IN and 1 OUT. So, if your setup uses 3
bidirection endpoints and only those, DWC3_USB3x_NUM_EPS should be 6.
DWC3_USB3x_NUM_IN_EPS specifies the maximum number of IN endpoint active
at any time.
However, I will have to double check and confirm internally regarding
how to determine many endpoint would be available if bidirection
endpoints come into play.
Thanks for pointing this out. Will get back on this.
Thinh
Ok. Just had some discussion internally. So, like you said, any endpoint
can be configured in either direction. However, we are limited to
configuring up to DWC_USB3x_NUM_IN_EPS because each IN endpoint has its
own TxFIFO while for OUT, they share the same RxFIFO. So we could have
up to DWC_USB3x_NUM_EPS number of OUT endpoints. So, the issue Bryan
attempted to address is still there.
However, the current code still has some assumption on the number of IN
and OUT endpoints, I need to think of a better solution.
Yes, the assumption still exists because at the time there was no better
solution :-)
Just found this now.
The commit log is too wordy. You can configure the RTL so that every
endpoint can be either direction.
So DWC_USB3_NUM == DWC_USB3_NUM_IN_EPS
The old code was predicated on the notion the RTL was configured with
EP0 IN/OUT basically fixed.
In practice this _should_ be the case but the RTL does not enforce it
and yes this appears in a real SoC from Imagination.
---
bod
