From: Marek Vasut <marex@xxxxxxx>
[ Upstream commit 9ad98319e95263469d8ca2cb543c37c5a2f40980 ]
On the production revision of the SoM, 587-200, the PHY reset GPIO and
touchscreen IRQs are swapped to prevent collision between EXTi IRQs,
reflect that in DT.
Fixes: 34e0c7847dcf ("ARM: dts: stm32: Add DH Electronics DHCOM STM32MP1 SoM and PDK2 board")
Signed-off-by: Marek Vasut <marex@xxxxxxx>
Cc: Alexandre Torgue <alexandre.torgue@xxxxxx>
Cc: Maxime Coquelin <mcoquelin.stm32@xxxxxxxxx>
Cc: Patrice Chotard <patrice.chotard@xxxxxx>
Cc: Patrick Delaunay <patrick.delaunay@xxxxxx>
Cc: linux-stm32@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
To: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
Signed-off-by: Alexandre Torgue <alexandre.torgue@xxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
index d30a3c60da9b0..a87ebc4843963 100644
--- a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
+++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
@@ -117,7 +117,7 @@ ðernet0 {
max-speed = <100>;
phy-handle = <&phy0>;
st,eth-ref-clk-sel;
- phy-reset-gpios = <&gpioh 15 GPIO_ACTIVE_LOW>;
+ phy-reset-gpios = <&gpioh 3 GPIO_ACTIVE_LOW>;
mdio0 {
#address-cells = <1>;
@@ -285,7 +285,7 @@ touchscreen@49 {
compatible = "ti,tsc2004";
reg = <0x49>;
vio-supply = <&v3v3>;
- interrupts-extended = <&gpioh 3 IRQ_TYPE_EDGE_FALLING>;
+ interrupts-extended = <&gpioh 15 IRQ_TYPE_EDGE_FALLING>;
};
eeprom@50 {
--
2.25.1
