From: Yonglong Liu <liuyonglong@xxxxxxxxxx>
[ Upstream commit a06656211304fec653c1931c2ca6d644013b5bbb ]
Enable promisc mode of PF, set VF link state to enable, and
run iperf of the VF, then do self test of the PF. The self test
will fail with a low frequency, and may cause a use-after-free
problem.
[ 87.142126] selftest:000004a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................
[ 87.159722] ==================================================================
[ 87.174187] BUG: KASAN: use-after-free in hex_dump_to_buffer+0x140/0x608
[ 87.187600] Read of size 1 at addr ffff003b22828000 by task ethtool/1186
[ 87.201012]
[ 87.203978] CPU: 7 PID: 1186 Comm: ethtool Not tainted 5.5.0-rc4-gfd51c473-dirty #4
[ 87.219306] Hardware name: Huawei TaiShan 2280 V2/BC82AMDA, BIOS TA BIOS 2280-A CS V2.B160.01 01/15/2020
[ 87.238292] Call trace:
[ 87.243173] dump_backtrace+0x0/0x280
[ 87.250491] show_stack+0x24/0x30
[ 87.257114] dump_stack+0xe8/0x140
[ 87.263911] print_address_description.isra.8+0x70/0x380
[ 87.274538] __kasan_report+0x12c/0x230
[ 87.282203] kasan_report+0xc/0x18
[ 87.288999] __asan_load1+0x60/0x68
[ 87.295969] hex_dump_to_buffer+0x140/0x608
[ 87.304332] print_hex_dump+0x140/0x1e0
[ 87.312000] hns3_lb_check_skb_data+0x168/0x170
[ 87.321060] hns3_clean_rx_ring+0xa94/0xfe0
[ 87.329422] hns3_self_test+0x708/0x8c0
The length of packet sent by the selftest process is only
128 + 14 bytes, and the min buffer size of a BD is 256 bytes,
and the receive process will make sure the packet sent by
the selftest process is in the linear part, so only check
the linear part in hns3_lb_check_skb_data().
So fix this use-after-free by using skb_headlen() to dump
skb->data instead of skb->len.
Fixes: c39c4d98dc65 ("net: hns3: Add mac loopback selftest support in hns3 driver")
Signed-off-by: Yonglong Liu <liuyonglong@xxxxxxxxxx>
Signed-off-by: Huazhong Tan <tanhuazhong@xxxxxxxxxx>
Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)
diff --git a/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c b/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c
index 52c9d204fe3d9..34e5448d59f6f 100644
--- a/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c
+++ b/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c
@@ -174,18 +174,21 @@ static void hns3_lb_check_skb_data(struct hns3_enet_ring *ring,
{
struct hns3_enet_tqp_vector *tqp_vector = ring->tqp_vector;
unsigned char *packet = skb->data;
+ u32 len = skb_headlen(skb);
u32 i;
- for (i = 0; i < skb->len; i++)
+ len = min_t(u32, len, HNS3_NIC_LB_TEST_PACKET_SIZE);
+
+ for (i = 0; i < len; i++)
if (packet[i] != (unsigned char)(i & 0xff))
break;
/* The packet is correctly received */
- if (i == skb->len)
+ if (i == HNS3_NIC_LB_TEST_PACKET_SIZE)
tqp_vector->rx_group.total_packets++;
else
print_hex_dump(KERN_ERR, "selftest:", DUMP_PREFIX_OFFSET, 16, 1,
- skb->data, skb->len, true);
+ skb->data, len, true);
dev_kfree_skb_any(skb);
}
--
2.25.1
