On Mon, Jun 22, 2020 at 11:46 PM Paul Cercueil <paul@xxxxxxxxxxxxxxx> wrote:
> Ingenic SoCs don't natively support registering an interrupt for both
> rising and falling edges. This has to be emulated in software.
>
> Until now, this was emulated by switching back and forth between
> IRQ_TYPE_EDGE_RISING and IRQ_TYPE_EDGE_FALLING according to the level of
> the GPIO. While this worked most of the time, when used with GPIOs that
> need debouncing, some events would be lost. For instance, between the
> time a falling-edge interrupt happens and the interrupt handler
> configures the hardware for rising-edge, the level of the pin may have
> already risen, and the rising-edge event is lost.
>
> To address that issue, instead of switching back and forth between
> IRQ_TYPE_EDGE_RISING and IRQ_TYPE_EDGE_FALLING, we now switch back and
> forth between IRQ_TYPE_LEVEL_LOW and IRQ_TYPE_LEVEL_HIGH. Since we
> always switch in the interrupt handler, they actually permit to detect
> level changes. In the example above, if the pin level rises before
> switching the IRQ type from IRQ_TYPE_LEVEL_LOW to IRQ_TYPE_LEVEL_HIGH,
> a new interrupt will raise as soon as the handler exits, and the
> rising-edge event will be properly detected.
>
> Cc: stable@xxxxxxxxxxxxxxx
> Fixes: e72394e2ea19 ("pinctrl: ingenic: Merge GPIO functionality")
> Reported-by: João Henrique <johnnyonflame@xxxxxxxxxxx>
> Tested-by: João Henrique <johnnyonflame@xxxxxxxxxxx>
> Signed-off-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx>
I have applied these two as non-urgent fixes for v5.9.
Are they urgent?
Are they causing regressions?
Tell me if they need to be merged to v5.8-rcs.
Yours,
Linus Walleij
