From: Jesse Brandeburg <jesse.brandeburg@xxxxxxxxx>
[ Upstream commit 765dd7a1827c687b782e6ab3dd6daf4d13a4780f ]
Currently the driver prevents a user from doing
modprobe ice
ethtool -L eth0 combined 5
ip link set eth0 up
The ethtool command fails, because the driver is checking to see if the
interface is down before allowing the get_channels to proceed (even for
a set_channels).
Remove this check and allow the user to configure the interface
before bringing it up, which is a much better usability case.
Fixes: 87324e747fde ("ice: Implement ethtool ops for channels")
Signed-off-by: Jesse Brandeburg <jesse.brandeburg@xxxxxxxxx>
Tested-by: Andrew Bowers <andrewx.bowers@xxxxxxxxx>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@xxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
drivers/net/ethernet/intel/ice/ice_ethtool.c | 4 ----
1 file changed, 4 deletions(-)
diff --git a/drivers/net/ethernet/intel/ice/ice_ethtool.c b/drivers/net/ethernet/intel/ice/ice_ethtool.c
index 593fb37bd59e..153e3565e313 100644
--- a/drivers/net/ethernet/intel/ice/ice_ethtool.c
+++ b/drivers/net/ethernet/intel/ice/ice_ethtool.c
@@ -3171,10 +3171,6 @@ ice_get_channels(struct net_device *dev, struct ethtool_channels *ch)
struct ice_vsi *vsi = np->vsi;
struct ice_pf *pf = vsi->back;
- /* check to see if VSI is active */
- if (test_bit(__ICE_DOWN, vsi->state))
- return;
-
/* report maximum channels */
ch->max_rx = ice_get_max_rxq(pf);
ch->max_tx = ice_get_max_txq(pf);
--
2.25.1
